I have had this done by a shop so I dont know what the difficulty is. It is a unitized assembly and contains the ABS sensor and wheel studs so it is an expensive piece. However check out the following website for instructions and pics on how to perform this task. http://mykidz.net/GTP/HubAssembly.shtml Hope this helps. "G"
how to change front wheel bearing 2001 jeep grand cherokee
You have to get a new hub with the bearing in it already.
Fron or rear?
How do you change a 1998 Jeep grand Cherokee rear wheel bearing you will have to remove housing in rear, break down axel, pull the side you are working on away from the wheel & replace bearing, it also requires a special tool to get into the housing case
go to you tube for a video on how to ...its there
Need to change the whole bearing...
how do you find out if wheel bearing is bad on a 2001 grand am gt
It is 175 ft lbs for the front wheel bearing of a grand cherokee
Did you ever find out how to change the headlight assembly? If so, please let me know how to do it :)
Remove a wheel bearing on 2001grand marqus
remove wheel remove brake assy unbolt wheel bearing from back air chisel out or hammer and chisel. clean area and reinstall
difficult to change really should be done by a professional,you can with time snake it out...i hate changing them.........
Difficult things are difficult to do.
how do i change the battery in my grand am gt how do i change the battery in my grand am gt
No, The bearing is what your wheel rolls and sits on. No bearing mean Wheel will come off.
What makes a supercharger squeal like a bearing is going out
how to change fuel filter on a97 grand am
There could be on at each wheel bearing.
The speed sensor is located inside the Wheel Bearing Assembly, and cannot be replaced separate from the Wheel Bearing Assy.
The 2003 Pontiac Grand Prix wheel bearing nut torque specification is 40 pounds. Do not exceed the 40 pound specification or you will risk causing the wheel seal to fail.
The bearing are sealed and can not be repacked.
55 foot pounds
They are a sealed bearing and are not greaseable.
Possibly at the Grand Canyon in Arizona.
Pretty difficult you will more than likely take have to take the whole dash out... It will be an all day job