You need to recover the R134 charge, remove the whole dashboard, then remove the a/c heater box to get to the heater core. The heater core should be accessible right next to the gas pedal. No dash removal is necessary.
Very hard.............. You will need to discharge the a/c system, pull back the dash and remove the complete a/c and heating box to remove the heater core.........
Drain the radiator. Remove the heater hoses from the fittings at the firewall under the hood. Loosen the dash, and pull it out enough to reach under to the heater core. unbolt the core, remove, then replace. Reverse the procedures to finish the installation.
The heater core is on the passanger side, located behind the bower motor housing on the firewall. If the car doesn't have AC it is not a difficult project. Remove the heater hoses from the firewall and then remove the screws that attach the cover to the firewall. The heater core rests inside.
how to remove a starter on 2000 dodge caravan
Remove the water supply hoses from your 1997 Nissan heater core. Remove the heater core retaining bolts. The heater core will come out.
- Remove wheel - remove caliper and brake pads - remove rotor - you should use a ball-joint separator (a.k.a. pickle-fork) to remove the ball-joint otherwise it is a very difficult process.
Remove the wiring harness from the back of your 2005 Chevy Cavalier heater blower motor. Remove the heater blower motor retaining bolts. Remove the heater blower fan.
You have to remove the dash and cowling underhood to remove the heater case. Then you would need to disassemble the heater case.
i have a 62 cadillac,how do you remove the heater core
it is possible to remove it from under the dash but difficult. Service manual says remove the dash. get more info from bonnevilleclub forum
Remove the center console remove the floor vent remove the heater core cover the heater core is right under the climate control unit remove the two screws that hold the heater core in place, open the hood and remove the heater hose from the heater core lines, now go inside and pull out the old heater core you don't have to remove the whole dash just the front of it
To remove the heater core on a 1992 Grand Marquis, first remove the dash board. Then remove the AC box to have access to the heater core.
Remove the center switch console. remove the 4 spring clips holding the square heater motor housing and remove the housing. Inside the heater motor housing Remove the two spring clips holding the heater motor in Remove wiring connections and then remove the heater motor. Install new heater motor and installation is in the reverse order of above.
Disconnect the heater lines going into the fire wall from under the hood. Remove the panels from under the dash. At this point you should be able to remove the heater cover and remove the heater core.
Disconnect the negative battery cable and drain the engine coolant.Remove the right rear quarter panel trim and then remove the panel itself.Remove the right rear wheelhousing liner.Disconnect the heater hoses from the core.Unplug the electrical lead. Remove the drain valve.Remove the heater module.If necessary, remove the blower motor.Remove the heater case cover.Remove the heater case cover and then remove the heater core.
Remove the kick plate on the passenger side of the passenger cabin. Remove the heater core water supply hoses. Remove the heater core retaining bolts.
# Disconnect the negative battery cable. # Drain the engine coolant. # Remove the instrument panel/dash assembly from the vehicle. # Remove the heater hose(s) and cap the hose(s). # Remove the attaching nuts and remove the heater unit assembly. # Remove the heater core attaching screw and remove the heater core..............
You first have to take the passenger side (bottom) dashboard out. You then remove (approx) 3 bolts from the inside and (approx) 2 nuts from the motor side. The heater core is inside the heater box. When the box comes off, you then remove the heater core from the box - after removing about 6-8 screws. It is more difficult than it sounds.
you must remove the dash it's in the heater box
Remove the passenger side fender and wheel well. Remove the blower motor wire. Remove the heater hoses. remove the nuts holding the heater box to the firewall. Remove the heater box from the firewall take out the heater core revese this process to replace all removed parts.
You have a rear heater core located in the rear on the passengers side..Drain the engine coolant.Remove the right rear quarter interior trim.Remove the right rear wheelhouse panel.Disconnect the auxiliary heater hoses from heater core.Disconnect the electrical connectors.Remove the drain valve.Remove the bolts.Remove the nuts.Remove the heater module.Remove the blower motor.Remove the heater case cover.Remove the heater core.
You have to replace the fan resistor pack. Open the glove compartment and lower the door, look in back on the firewall. Remove the two screws and the connector, pull out the resistor pack - replace it.
You can access the heater core from the passenger side kick plate in your 1964 Chevrolet Corvette. Remove the heater core water supply hoses. Remove the heater core retaining bolts. The heater core will come out.
Remove the water from the cooling system. Remove the water hose from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.