answersLogoWhite

0


Best Answer

Probes were not made until 1989

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How difficult is it to replace the starter in a Ford Probe It's a 1985?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a starter in a 1985 Olds 98?

To replace a starter in a 1985 Olds car, raise the front end of the car with a jack, Next, remove the two support bracket bolts at the transmission and pry the support bracket away slightly to obtain access to the starter bolts.


How do you change the axle in a 1985 ford probe?

THERE WAS NO FORD PROBE IN MODEL YEAR 1985


How do you replace the starter on a 1985 Chevrolet Silverado C20 Pickup?

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter


How do you change a starter in a 1985 Pontiac sunbird?

Changing a starter in a 1985 Pontiac Sunbird is not very difficult. The car will first need to be jacked up. After the car is jacked up, locate the starter. The wires will need to be taken off the starter and labeled so they can be reattached to the new starter. The starter is then taken down by using a ratchet to take of the bolts. After the starter is taken off, the new one can be put on.


How do you remove starter bendix 0n 1985 harley Davidson fxr?

how do i replace the bendix drive in my 85 harley fxrs


How do you remove and replace a starter on a 1985 Chevy C10?

disconnect battery-crawl underneath,unbolt existing starter,undo related wiring-reverse with new unit,reconnect battery, have a beer


Starter 1985 Crown Victoria ltd?

You can find the starter for the 1985 Lincoln Crown Victoria LTD online at places like Rock Auto. AutoZone also offers the starter for this vehicle.


Where is the Starter for a 1985 F250 Diesel?

On the transmission.


Why does my starter on my 1985 ford ranger 2.6l v-6 4 wheel drive grind or not engage with the flywheel properly?

It could be that the starter pinion drive (also known as the bendix) is worn. If it is grinding and roatating slowly, then the bushings are worn. In either case, you neep to overhaul or replace the starter.


Where is starter on 1985 MR2?

The starter is on the left side (inside) of the engine underneath the exhaust manifold.


How do you remove a starter from a 1985 Chevy 3500?

with a hammer


Were is the relay on a 1985 camero?

i dont have no power to my starter solinode wont start its a 1985 camero