tire off, brakes off, tie rod off, disconnect strut, and a few holding bolts. axle will slide out with a little bang from a hammer or a little pull if your lucky
does a 2002 mazda protege have a front wheel drive
yes
The ECM on the 2000 Mazda Protege is located on the backside of the engine. It is half way up above the drive shaft.
chain the axle to a tree and just drive away. It's gone man.
I have a Mazda protege 1996 that is parked because it will not go into drive but the engine starts?
I have been told that is a sign of a problem with your torque converter.
There are a couple of things that can cause your Mazda to cut off and be stuck into the drive gear. The most common causes are a broken shifting fork or a malfunctioning transmission fluid pump.
Yes, you must pull both axles to change any transmission, Mazda or not.
If it is a 2-wheel drive then it has 2 axels in the rear and the 4-wheel drive has 4 axels. in the rear and 2 in the front.
needs a coil or distributor it could also be that the alternator isn't working and the car may be draining the battery every time you drive it
Might want to check the secondary ignition system. That is everything from the coil(s) to the spark plugs.
Check the wheel bearings and the front brakes for wear. These are the most common places that cause the roar.