Toyota Highlander
Timing Belts and Chains
Chevy Trailblazer

How do change the timing belt in a 1984 Oldsmobile Toronado?

697071

Top Answer
User Avatar
Wiki User
2015-07-15 21:18:17
2015-07-15 21:18:17

what size motor is in your car is it the 307,350 V8 or the 252 V6

if it is the 307 or 350 it will be a timing chain and from what my book shows the 252 has a timing chain to

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

If I remember right these are 4" by 10" and you need to access them through the trunk.

User Avatar

"http://wiki.answers.com/Q/How_do_you_change_the_timing_belt_on_your_1984_Honda_Civic"

User Avatar

I need a belt diagram to an 1984 Oldsmobile 98 5.0 size motor

User Avatar

where are the timing marks on a 1984 mazda b-2000 pickup?

User Avatar

How to set timing on 1984 Honda 200s 3wheeler

User Avatar

Timing light. The instructions are on the engine hood.

User Avatar

Oldsmobile was a brand of vehicles built by GM. They are no longer build. I own a 1984 Cutlass Supreme in beautiful condition.

User Avatar

To set the timing on a 1984 Chevy Celebrity with the V6 engine: 1. Disconnect the HEI connector so the engine will run in closed loop. 2. Start the engine and use an inductive timing light to check the timing. It should be at 100 before top dead center 3. If the timing is off loosen the clamp at the base of the distributor and turn the distributor so that the timing is set. 4. When you have set the timing tighten the clamp and verify that the timing did not change. If it stayed the same reconnect the HEI connector.

User Avatar

best to replace it then bleed the brakes

User Avatar

Check out my bio page for help on setting your timing.

User Avatar

up until the 1985 models of subaru they didnt have timing belts. instead they have a gear that runs off of the crankshaft, making the older subarus(1984 and older) the most reliable cars ever made. i personally drive a 1984 GL 1.8L non turbo, and have done the rebuild. my ODO is at 259922.2 mi.

User Avatar

It is located under the timing cover and it is driven by the timing belt.

User Avatar

Every 1980 through 1984 Oldsmobile Ninety-Eight had a 5 liter (307 cu. in. Oldsmobile) V-8 with Rochester QuadraJet (4 barrel) carb.

User Avatar

How do you set the timing on an 1988 ford ranger 4 cylinder

User Avatar

Was there a 1984 Oldsmobile Cutlass Calais? I see them listed at 1988-1991. Assuming that you mean "wiper blade" (blade and frame) which are replaced often rather than "wiper arm" (piece from the spindle at the hood to the wiper blade) which are rarely ever replaced, ALL 1988-1991 Oldsmobile Cutlass Calais' have 3/16" Side Lock wiper arm attachments. See Sources and Related Links below.

User Avatar

You will probably need to replace power steering hose-I have owned several toronados and generation two bodies with 307 v8 always leak at power steering hose eventually-especially with high miles-replacing hose always worked for me. When this hose leaks it tends to get fluid on belts making them squeel

User Avatar

Miami Vice - 1984 Bad Timing 5-4 was released on: USA: 2 December 1988

User Avatar

Follow the fuel line down from front of the carburetor.

User Avatar

ground the diagnostic connector under the dash , set the timing , then unplug connector


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.