Tumbler door locks work with the key being put in the lock and tumbler turning. This is one of the most common types of door locks.
what about them? yeah for real, my door locks work pretty well.
power door locks don't work on my 1997 Honda crv
ANYTHING could happen to make it not work.
If a locksmith has failed to open a door then, Wedge the door glass to door shell open in order to trip the latch with a long metal rod. This requires Patience and some time to get it right.
Is the remote's battery dead?
The automatic door locks on a Dodge Intrepid won't work if the fuse or switch are bad. These two components should be checked first to narrow down the cause.
my discovery 3 rear door lock will not lock with remote
Metal door locks are made of metal.
you might have the child safety locks activated
I have a 2001 Nissan quest,recently my door locks are malfunction,when I pull the door in it locks,when key in ignition it locks,what cause this problem?
We have a 2000 Montana and yes it does have automatic door locks.
Check the fuse.
How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches
No. The door locks will not work with out power.
Remove the relay or fuse for the door locks.
First thing would be to check the fuse for the circuit. If it is ALL the doors that don't work it is likely the fuse or in the wiring somewhere. If only one of the door locks doesn't work, it could be the electric solenoid (located inside the door) that controls that particular lock.
"Replacing a power door lock on a 4door pont G6
Power door locks use a small electric motor to pull or push the door lock mechanism in order to lock or unlock the door. They are located in the bottom part of the door where they get wet and dirty and can simply become too gummed up to work. On those that still tried to work I have tried using WD40 to clean and lube them with only marginal success. New power door locks are still available, but not cheap.
Relay overheating or short in wiring harness. Try hitting the door the next time they don't work or kicking the firewall.
The switch itself is most likely bad
bad wire or actuator
short in motor of door.
If it was made before '92, it's not supposed to.