Cooling SystemEnsure that the engine is completely cool prior to starting this service. 1. Remove the recovery tank or radiator cap. 2. Raise and support the vehicle. 3. Place a drain pan of sufficient capacity under the radiator and open the petcock (drain) on the radiator. è Plastic petcocks easily bind. Before opening a plastic radiator petcock, spray it with some penetrating lubricant. 4. Drain the cooling system completely. 5. Close the petcock. 6. Remove the drain pan. 7. Lower the vehicle. 8. Determine the capacity of the cooling system, then property refill the system with a 50/50 mixture of fresh coolant and distilled water. 9. Leave the recovery tank or radiator cap off to aid in bleeding the system. 10. Start the engine and allow it to idle until the thermostat opens (the upper radiator hose will become hot). The coolant level should go down, this is normal as the system bleeds the air pockets out of the system. 11. Refill the system with coolant to the proper level. 12. Turn the engine OFF and check for leaks.
there is a drain plug on the bottom tank of the radiator
You have to remove the bottom radiator hose.
The most effective way to drain a fiesta is to remove the lower radiator hose at the radiator end
2002 t/bird cooling drain pug location
The radiator drain plug on a 1992 Ford Thunderbird is located on the bottom, left side of the radiator. It allows for the cooling system to be quickly drained during maintenance.
You can find a 1992 Ford Bronco cooling system diagram at most Ford dealerships. The diagram will be in Ford service manuals at your local library.
To bleed the cooling system on a 96 Acura 3.5 L, cool the radiator and remove the radiator cap. Loosen the drain plug and drain.
drain the whole cooling system and refill it. You will never know if you don't give details of your car!
The cooling system helps keep the car from running too hot. A diagram for the 1998 Ford Taurus cooling system can be found in the car's maintenance or repair manual.
If you do not have a radiator cap once you drain the radiator, you can use several options to flush the cooling system. You can easily do this by filling up the system with as much water as you can and then warm it up.Ê
Remove the lower radiator hose or loosen the radiator drain.
there is no "block drain", just remove the lower radiator hose to drain the block