0
Add your answer:
Earn +20 pts
How do I install a water pump on a 1998 Pontiac Bonneville?
You have to remove the motor mount. Once the motor mount is removed you can remove the old water pump and install the new one. Make sure the area is clean before you install the new one.
How do you change a starter on a 1998 s10 The motor mount gets in the way?
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
How do you remove a passenger motor mount?
in removing motor mount what bolts need to be removed. This is a 1998 biuck regal 3.8L, and I am not sure how to remove the motor mount.
Front motor mount on a 1998 grand am adjustable?
Probably not
What type of motor oil is for a 1998 Ford Explorer xlt?
5 W - 30 is the preferred oil for all 1998 Ford Explorer engines
Starter removal 1998 harley dyna?
install starter motor
Can you put a 1991 Ford Explorer motor into a 1998 explorer?
If you use the motor mounts off of the 1991 explorer also, it will fit and transmission should line up if it is same size motor. If going from a automatic to a standard, you will have to replace the flywheel.
Where is the wiper motor pulse board module on a 1998 Ford Explorer 4.0 L?
The Ford Explorer was produced from the years 1990 to present. The wiper motor pulse board module in a 1998 Ford Explorer 4.0 L is located on the firewall, behind the engine in the middle.
What size v-8 was 1998 ford explorer offered with?
5.0 liter motor
I have a 1998 Mazda Protege that shudders when you stop the car. It only happens once the car has stopped moving after I have driven it for a little while. Does anyone know what could cause this?
have your motor mount checked my protege did the same thing and it was the front motor mount have your motor mount checked my protege did the same thing and it was the front motor mount have your motor mount checked my protege did the same thing and it was the front motor mount
Where is the starter on a 1998 Chrysler Sebring jx?
It is on the front of the engine, behind the motor mount.
How do you unbolt - replace the engine motor mounts on a 1998 Ford Windstar?
on the front motor mount remove lower 18mm nut loosen back lower motor mount 18mm nut jack up front part of engine then remove top bolt on frount motor mount you need a 18mm swivel scoket with a long extion remove nut then remove mount. rear would be the same way do only one side at a timeYou first have to remove the air conditioner compressor out of you way then jack up the motor, then undo the old motor mount bolts, top and bottom, then install the new mount. then put back together in reverse order.
