First you must unscrew the oil filter and remove the 2 lines going into the adaptor. Unbolt the 2 bolts holding the adaptor to the motor. Remove the adaptor. Clean gasket from adaptor and block. Replace gasket and resemble the way you took it apart. You can take the oil filter off then take the 2 bolts out of the adapter plate this will allow the adapter to be pulled down enough to replace the gasket witch is an oring. If you take the lines off they are quick release.
The common consensus is 1200 to 1500.
head gasket? Between $800 and 1,800.
How do I replace the heater core in a Chevy express 1500
how do replace a power steering hose on a Chevy c-1500 pickup truck
What year,what motor?? it is a 2002 Chevy avalanche 1500
replace heater core in a 1991 Chevy work truck 1500
if it has lines going from your oil filter adapter to a cooler in front of your radiator
yes. if they are original.
Hey John==It is quite involved. Get a manual from the local parts store and it should have pictures and everything. Good luck, Joe
Whats the easiest way to get broken cab mount bolts out on a 1994 chevy 1500 extended cab
how to clean evaporator on 1997 chevy 1500
ballpark $1500 sight unseen
If you look up under the back of the truck at the rear end housing, you will see a round plate with at least 10 bolts in it. Take all the bolts out. When you remove the plate grease will run out. Clean old gasket off, replace with new gasket, Put plate back on and fill with grase.
There are two knock sensors on a 2001 Chevy 1500 with the 5.3 V8. You have to remove the intake manifold, because both of them are located under it. it is best to replace both knock sensors at one time, and you will need an intake manifold gasket too. There are two knock sensors on a 2001 Chevy 1500 with the 5.3 V8. You have to remove the intake manifold, because both of them are located under it. it is best to replace both knock sensors at one time, and you will need an intake manifold gasket too.
does anyone know the torque for cast iron exhasut on aulm heads ..small Chevy
The oil pan must be removed.
most you just push and twist it out.
You need to replace your booster.
Sure, You will have to change everything,motor mounts,computer,wire harness, exhaust, etc...
It can cost anywhere between about 700 dollars and about 1500 dollars to replace a blown head gasket on the 1999 Dodge Neon. This varies depending on location and condition of the vehicle.
buy a tap and die set.
Dealership price is around 1600 dollars
you will need two people for this job, go to an automotive sotre and get " gator wire" it has one sharp edge, poke a hole in the rubber gasket to feed the wire though and then go back and forth using the wire like a saw and it will cut the gasket and release the window.
Your oil is (most likely) not leaking into your exhaust but rather through the head gasket into the cylinder(s). You have to machine your head and replace the gasket. (I don't recommend trying this on your own if it's your first time) I'm assuming of course that you have BLUE smoke coming out of your tail pipe.... if not clarify...
if your asking how to replace the t-stat you remove the bolts clean gasket area install new gasket and t-stat. if your asking the location its on the front side of intake left rear of a/c