I lost my retainer in the rear cupholder in the 1998 Ford winstar and it wasent good! I couldn't get it out . So my dad used a screwdriver to pry the cupholder out, then he used the screw driver to undo the bottom panel.After about 30 min.of trying to pry it out I stuck my hand in were the cupholder was and tried to grab it, it fell to the bottom of the panel and then we just was able to grab it out of the bottom. It was difficult but all we needed was a screwdriver and a small hand .
To remove a water pump from a 1998 Ford Windstar 3.0, you will need a tool called a tensioner. Disconnect the radiator and water hoses, then remove the water pump assembly.
Replace freeze plug in a 1998 ford windstar ?
A 1998 Ford Windstar would use refrigerant 134a
It is very simple. In the center of the holder when is pulled out as far as it will go, use a srewdriver blade to push down the tab. The cup holder will now pull out.
it is on the trans,right side you will have to remove cat.converters to access.
On a 1998 Ford Windstar : The 3.8 liter V6 engine ( and the 3.0 ) has a timing CHAIN
On a 1998 Ford Windstar : ( # 16 / 20 amp )
Not likely - the 1999 Windstar was a rather significant updating of design compared to 1995-1998 models.
Reverse backwards and hit a boulder.. that thing will rip right off!
On a 1998 Ford Windstar ( 3.0 and 3.8 ) firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
How do i remove the rear back seats of my ford windstar minivan for cargo space
On the underside of the engine.
It does not have one.
Mostly in the Windstar category - they all apply to the GL model
In a 1998 Ford Windstar : There were 2 engine sizes offered from the factory : A 3.0 liter V6 engine and the 3.8 liter V6 engine
take it to a shop.
Follow the LOWER radiator hose from the radiator . It connects to the water pump on the engine on a 1998 Ford Windstar
no it did not
A Chevrolet Dealership
The fuse box diagram for a 1998 Ford Windstar van is located on the inside cover of the box cover. It can also be viewed within the service manual.
According to one of Fords websites : For a 1998 Ford Windstar ( 3.0 and 3.8 ) The ( Motorcraft FL-400-S ) engine oil filter is used
On a 1998 Ford Windstar ( 3.0 and 3.8 liter V6 engines ) It uses a 4 speed automatic / overdrive transaxle ( transmission )
A 1998 Ford Windstar has the Electronic Distributorless Ignition System ( EDIS ) so there is no distributor . It uses ( 1 ) coil pack that has ( 6 towers ) for the spark plug wires