32ftlbs for the pin bolts
To replace the belt on a Nissan Frontier, first loosen the idler pulley of the belt and remove the bolts. Then slip the replacement belt onto the pulley and put back the bolts.
Remove the flex plate access panel at the bottom of the trans where it meets the engine then remove one bolt and turn the crank to access the next till all are out
25 ft lbs on pressure plate and 50 Ft lbs on the flywheel bolts. use locktite
Snap-on socket # SLEPL 200
there are two bolts on the inside corner, i believe they are Philips screws
The flywheel for the FWD tranny should have 6 bolts. The turbo flywheel has 100 teeth and the nonturbo should have 106. The AWD flywheel should have 7 bolts.
remove the enigine and then take out flywheel bolts
Torque converter bolts No. Fly-wheel bolts YES.
80Lbs for flywheel, 10 to 15lbs for pressure plate
it is located on the lower right side of the engine bolted to the transmission. not too hard to access the bottom bolt but the top may need a universal for your ratchet. the bolts are 9/16 inch.