you have to remove the housing nuts from the inside the trunk; it is very akward getting to them; then you should be able to get at it from there or from lifting the unit out from the inside of your car.
?need to replace the cable to a 1979 buick regal, the emergency release mechanism wire broke. Don't know how to release the brake?
On my 1990 Buick Regal, I need an 18mm wrench , a 10mm wrench, screwdriver, jack, and a can of brake cleaner
Located on the firewall behind the emergency brake.
The fuse box on a 1986 Buick Regal is located below the dash near the brake pedal. It prevents circuits in the vehicle from being overloaded.
That's a very good question, please Can someone answer it or is it that uncommon of a thing. 96Buick regal custom 3.1 Headlights are off when you have parking brake on and turn ignition over, but after you lift parking brake the only way to turn off the lights is to turn off the ignition fully.
Check the ground wire for the associated fixture.
Master cylinder, upper firewall, driver's side.
to the left of your brake pedal there should be a little hatch. its behind that
Remove the two bolts that hold calliper to bracket and disconnect brake fluid line. The bolts are probably metric #15. Bolt new calpers back in connect brake line and you will need to bleed brakes to remove air from system.
Foot on brake pedal or linkage to trans is loose or out of adjustment.
The popping noise from a Buick Regal could be one of several things. You could have brake issues, or some problem with the suspension. Left unimpaired, the car could break down at any time.
push the parking brake ,before starting the engine
Probably your emergency brake pedal. Try lifting up on your e brake pedal and see if id goes out.
Check your Brake fluid. If the fluid is low then will make the Brake light go on. anothe thing is you might be needing new brakes soon..
Most likely it is either the brake light switch, under the dashboard, connected to the brake pedal or the turn signal switch inside the steering column.
Check your turn signal switch (the electrical part, not the lever). I had the same problem on a 1998 Chevrolet Lumina and that's what it turned out to be.
Should have an access panel inside trunk
you have to have a tool called a cube. it is bought at most auto parts stores for under $15. once you have that secure the caliper and put your wrench to tighten and just keep cranking it until it is all the way in.
Should be a screw on either side - remove and cover should lift off
There is a problem with the Anti-Lock brake system. Seek professional help.
Perhaps a vacuum leak check power brake booster and check valve at booster
Well, if pulling the "brake release" lever doesn't work... don't know what to tell you
How to repair brake lines on a 91 buick
I just did my Mom's 1991 Buick regal 3.8L. I removed the kick panel underneath the dash above the brake pedal. Follow the brake pedal arm up on the right side of the pedal. I used a mirror to spot the flasher unit. The flasher unit is held by a spring clip with the top of the unit pointing down. Just pull the flasher out of the clip and pull it down.
How to change brake lines on a 1991 Buick Lesabre?