answersLogoWhite

0


Best Answer

Your best bet is to take a tennis ball or rubber raquet ball and throw it at one of the windows. It wont damage the car, but the vibration should set off the alarm.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you activate the factory alarm on a 2007 Toyota corolla?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you disarm a 1990 Corolla factory alarm?

i need a control alarm


Why Factory fitted alarm for 2003 corolla wont arm?

The factory fitted alarm on a 2003 Corolla will not arm if the wires have been cut to the alarm. If the vehicle was purchased used, this is a good possibility.


Where is the fuse for your alarm system on a Toyota Corolla?

The fuse for the alarm system on a Toyota Corolla is located in the driver kick panel. The fuse will be labelled D/L or DOME.


Does a 1995 Toyota tarago have an alarm?

does a Toyota tarago GLI 1995 model come with a factory alarm


How do you reset the Toyota Tundra factory alarm?

In most cases the Toyota tundra factory alarm will reset itself after 10 minutes. You can also pull the fuse out for 10 seconds and replace it to reset the alarm.


How do you reset your 1997 Toyota Corolla VIP alarm so it will start again?

ok


How do you adjust the sensitivity or reduce of Toyota Vios car alarm?

a yellow light shows up on the dash board on my 2008 Toyota Corolla


How do you disarm a 1999 Toyota Tacoma factory alarm?

why don't you just ask, how do I steal a 1999 Toyota Tacoma


How do you activate a factory installed alarm with an ignition key with a chip on it for a Buick Park Avenue?

This can only be done at a dealership.


How do you turn off the factory alarm for a 2001 Toyota Celica?

To turn off the factor alarm on a 2001 Toyota Celica, place the key in the door and unlock it. If this does not disconnect the alarm, place the key in the ignition and turn it over.


How do you disarm a 1997 Toyota 4Runner factory Alarm?

To disarm a 1997 Toyota 4Runner factory alarm, place the key in the ignition. Turn the key about halfway ensuring the car does not start. Leave the key in that position for 10 to 15 minutes and start the car.


How do you disarm a 1998 Toyota 4Runner factory alarm system?

While the alarm is beeping, turn the ingnition to on position push the button in then take the key out.