How do you add freon to a 96 Ford Contour
Answering "Where do you add freon to your air conditioner in your ford ranger?"
On a 1996 Ford Thunderbird : Through the automatic transmission fluid dipstick tube ( using a funnel ) The dipstick is located near the firewall , in the engine compartment , on the right side of the engine ( passenger side )
Contains no Freon. Freon was banned beginning in 1996.
how to add freaon in a 2003 ford escape
It is either on or near the recievr dryer in the right rear of the engine compartment. To corrrectly add freon, you need gauges and a refrigerant recovery system
You can add Freon to your 1996 Mercedes-Benz air conditioning system through the low pressure port on the air conditioner compressor. Connect your Freon bottle to the low pressure port. Release the Freon into the system.
I have a 1996 land rover 4.0 and need to add freon. I have the gauge, but don't know where to connect it to
Which do i hook to to charge the freon in a 2004 ford expedition
on the low side only
The 1996 Suburban uses r134 Freon. The fittings to add Freon are different sizes on r12 and r134, making it impossible to add the wrong type to your vehicle.
FreonThe connection is on or close to the receiver dryer. If you add too much, the compressor will lock up or it won't cool very good. They don't sell Freon any longer. By the way, your car takes R134A refrigerant. If you add Freon, you ruin it.
Use a tranny funnel and add through the dipstick tube.
There is one valve that is used to add refrigrant. But you had better not add Freon. Freon is R12 and your vehicle's A/C system does not have Freon (R12) as a refrigrant. More than likely it uses R134a.
On the suction side, the low side...................
Through dipstick tube-auto?
freon usually goes on your condinser there should be a place to add collant on your condinser which is a silver cylinder
Freon was not installed in any vehicle built after 1995.Freon was not installed in any vehicle built after 1995.
where is low pressure valve on a 2005 ford 500? i am trying to add freon
Low pressure line\ Larger hose from the compressor
Freon is added through the ac low pressure port. The port is located on the aluminum pipe on the ac line.
Probably 5-6 quarts Add 5 and check
Freon is added in the low pressure port of the ac system. It is on an aluminum pipe on the passengers side, close to the ac drier.
You don't add Freon as it has R134a not Freon. You add it to the low pressure side which is the larger hose.