it is added to the suction side. Identified by compairing the lines of the A/C system the LOW side is always bigger then the HIGH side line. NEVER add freon to the HIGH side... Late models do not have a sight glass telling you when it is full, now days you HAVE to weigh the freon before you add it, thusfor the system must be drained and vaccumed down to 30 in for at least 30 min. Yea you can get a can and a hose and just add but this is DANGEROUS! Rick ASE L-1 Master TransMichigan.com
In the low side ac service port.
The 1999 Olds Intrigue does have a dipstick. Use a funnel to add fluid as needed into the dipstick tube.
The 1999 Oldsmobile Alero does not have Freon in the A/C system. It contains R134 and not Freon which is R12. As I am sure you do not have the proper equipment to recharge the system plus the fact it is illegal to add refrigerant to a system with a leak, until the leak is repaired, take it to a professional and have the leak repaired. You have a leak or you would not need to add refrigerant.
How do you add freon to a 1999 Honda Passport
Yes...water works really well
You don't add Freon as it has R134a not Freon. You add it to the low pressure side which is the larger hose.
FreonThe connection is on or close to the receiver dryer. If you add too much, the compressor will lock up or it won't cool very good. They don't sell Freon any longer. By the way, your car takes R134A refrigerant. If you add Freon, you ruin it.
You can add Freon to your 1999 Chevy cooling system through the low pressure port. Connect your Freon bottle to the low pressure port and release the Freon into the system.
Freon is added into the low side ac port. Using the proper type Freon, and a gauge that works with that type Freon, connect the hose to the port. With the engine running allow the Freon to flow until the gauge reads in the ok range.
Low pressure line Larger line running from compressor
Through the schrader valve on the low pressure side.
you need a funnel. stick the funnel into the hole where the trans. dipstick goes in. insert new fluid .
Find the low side ac port on the 1999 DeVille and connect an ac gauge and freon tank. Start the engine, turn the ac on high, and open the freon valve. Let the freon flow until the gauge reads full.
You can add Freon to your 1999 Chevrolet S 10 pickup truck cooling system, through the air conditioning compressor ports. The ports are located on the top of the compressor. You would add r134 refrigerant through the low pressure port located on the accumulator/dryer.
Take it to the a auot shop. you can not add freon
Contains no Freon. Freon was banned beginning in 1996.
Freon is added through the low side ac pressure port. Connect the hose from the gauge and Freon and allow Freon to fill the system until the gauge shows full. The engine and ac need to be running during this process. Make sure to follow all directions on the Freon can.
where do I add freon to my air conditioning unit on a 1997 chevy truck?
Answering "Where do you add freon to your air conditioner in your ford ranger?"
You add freon to the low side fitting,top front,on the ac compressor
You add freon to the a/c by using the low side, suction side (larger hose).............
You call a licensed contractor and have them check your system. If they determine that it needs freon, they can add the right punt.
You can add freon on the low side service port that is located on the accumulator next to the firewall................
In order to buy freon you need a license, therefore you shouldn't attempt to add freon. Call a contractor to service your unit.