You dont adjust the Idle disconnect the battery for 10 mins and reconnect and the computer should relearn it idle .
how do you adjust the idle on a 2002 toyota van
you can adjust it via the idle control valve.
Trouble code P0505 means: Idle Air Control System
smash it into the wall
a/c kicks on
You cannot adjust the idle in a 1998 Cadillac Catera. It is computer controlled. If the idle is not at 750 rpms then there is another problem with the engine. Check for codes with an OBD2 tester.
maybe the clutch
there is an Allen screw and a nut on the throttle cable you loosen the nut and the screw and adjust it to make it idle up or down.
The idle speed is computer controlled and is not adjustable.
Honda Accord 1998-2002 model GEN 6 idle speed is control by internal computer. You need to bring it to the dealer to adjust this.
According to the Haynes manual, it is not adjustable.
You adjust idle with idle timing
Adjust idle on Mitsubishi diamante
Check idle speed rpm & adjust higher if lower than it should be. Mixture if it isn't.
The idle adjust screw is on the throttle body. The side of the throttle body that faces the front of the car should have a dime size flathead screw towards the upper edge.
You can't. Toyota Camry uses throttle position sensor to adjust idle. If your car does not idle you need to check computer for error codes. If you do not have any, most likely you will have to do tune up on your engine and maybe even fuel system. But starters check the air filter and replace if you did not do that in a while or if it looks dirty.
fix the vacuum leak
If it is throtle body equipped, the idle control s solonoid controls it. If it has a carb there is an adjustment screw on the bottom of the carb.
how to adjust idle on 2001 legacy
AnswerUsually you can't adjust the idle on a newer vehicle. An abnormal idle would indicate a problem elsewere in the vehicles engine or emmissions system.AnswerUsually the problem lies in the IAC (idle air control) valve. It probably needs replaced.
The idle adjustment screw is located on the IACV behind the manifold on a 1998 Honda CR-V. Open the latch on the IACV then take an screwdriver and tighten the adjustment screw.
check your idle intake valve for proper operation, to check means you would consult the test procedure in a published repair manual from either the manufacturer or auto repair store (haynes or chilton). hope this gets the tacoma running!
Idle speed is computer controlled and is not adjustable. If the speed is incorrect there is a sensor, actuator, or mechanical failure.
Idle speed on a 1998 Chrysler is computer controlled and is not adjustable. If idle speed is incorrect, you have a sensor, actuator, or mechanical failure. Places to start are, check for engine fault codes. Check for vacuum leaks.