Buick Riviera

How do you adjust the belt tensioner on a 1998 Buick Riviera?

272829

Top Answer
User Avatar
Wiki User
Answered
2005-09-04 03:58:42
2005-09-04 03:58:42

Automatic belt tensioners do not require adjustment as they are spring loaded. They get replaced.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions






The 1998 Buick Riviera air conditioner compressor is located in the engine compartment. The air conditioner compressor will be on the left-hand side of the engine.


first you need to state what liter the engine is.


check fuse or see if its plugged in under the seat


Your Explorer has a serpentine belt tensioner which keeps the proper tension on the serpentine belt unless the tensioner has failed.



It is under a plastic cover behind the passenger side headlamp assembly.


The official coolant is Dex-Cool (orange). However, you can use yellow. Do not use green


Easiest way is to just pull the horn relay.


They have automatic tensioners. If the belt needs adjustment, either you have a bad tensioner or a worn belt.


you have to call any GM dealership and ask for the parts department and they will give you one for about $35-50.


Put the belt tensioner tool on the tensioner pulley, and push away from you. Then you can slide the belt off. You either need to cut it or unbolt the engine from its mount and slip it out.


Using a 14 mm wrench, loosen the bolt in the center of the tensioner pulley, then tighten the tensioner bolt with the same wrench. Then re-tighten the bolt in the center of the tensioner pulley when the belt is tightened to your liking.


If you ask a question like that, on a forum like this. Go back to world of warcraft, take it to a mechanic, and have your parents pay for it.;


There is a Tensioner Pulley that you have adjust in order to tighten the belt. There is another hex bolt that can be screwed in or out depending on how you want to tighten or losen the belts. Adjust it until prefered tension is reached.


"How do you move the idle tensioner for a 1998 3 litre dodge?"


look on passenger side, front fender. Should see a small red box, flip it open.


I have used a socket with a ratchet handle. The ratchet will allow you to get more travel to move the pulley and get the belt off.


there are two belts, one for the accessories; alternator, power steering pump, AC..., then there is one expressly for the supercharger


were can i locate and replace a starter for a 1998 buick regal?


There is a special tool for that. Try a GM dealer's service center. They should know which one it is.


how do i adjust the handbrake of a hyudai elantra 1998 model



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.