If you are refering to the cam belt tensioner, they are spring loaded and self adjusting. The V6 tensioner can lose tension and become very noisy, if this is the case, replace the belt and tensioner. If, however, you have an ealier model, you will have up to 3 manual tensioners. Tightening the bolts on these loosens then tentioner (moves the wheel down) IMPORTANT: Don't forget to tighten the lock nuts when you're done adjusting!! :)
Remove beltUnbolt tensioner and remove
I think it is the same as my 98 and you put a wrench on the bolt at the center of the tensioner pulley and push away from the belt.
Not unless the bearing in that pulley is noisy or rough when you spin it.
diagram for timing belt Isuzu rodeo 3.2l 24valve
the water pump is driven by the timing belt. highly recommended to replace the tensioner, tensioner and idler pullies, and cam seals.
u do not adjust belt tensioner if belt is loose, u need to replace belt as tensioner works automatically
how do you change the serpentine belt on a 2001 Rodeo
You can adjust the belt tensioner by loosening the tensioner bolt. When the tensioner bolt is loose the tensioner pulley can move back and fourth.
loosen the 7/8 main nut on the tensioner then back off the adjuster 12mm till there is enough slack to remove the belt
it¨s a timing belt..
The belt tensioner is self-adjusting.
There is no way to adjust the belt tensioner, if it's not keeping enough tension on the belt the complete tensioner itself will need replaced.
There is no adjustment on the spring / Tensioner. You either have the wrong belt are the tensioner itself is bad. Replace tensioner are belt.
you dont,the tensioner tightens the belt up.if belt sqeals get new belt or tensioner! on 3.1v6,
What about this tensioner? How do you remove it, or how do you releave the tension so you can replace the belt?
The water pump is the tensioner for the timing belt. if you need to adjust it, replace it.
You dont! The belt is self adjusting with the belt tensioner. Check the tensioner for failure or damage if your belt is loose good luck
You cannot adjust the belt tension on a 2000 dodge grand caravan. This vehicle is equipped with an automatic tensioner. If tensioner is frozen or will not hold the belt tight, it must be replaced.
Done automatically by belt tensioner
Should have a spring loaded belt tensioner
Your Explorer has a serpentine belt tensioner which keeps the proper tension on the serpentine belt unless the tensioner has failed.
Please show picture of how to put on belt
There is an adjuster on the power steering pump. One cannot adjust it as it has an automatic tensioner if the belt is squeaking it is time to replace belt/tensioner or both
It is behind the timing belt cover.