Chevy Silverado
Nissan Xterra
Ford F-150

How do you adjust the driver-side door on a 1992 F-150?

282930

Top Answer
User Avatar
Wiki User
2007-03-12 21:02:00
2007-03-12 21:02:00

Try loosing the bolts that hold the hinge to the body. Just enough to raise or lower the door. Then tighten and adjust accordingly. You can adjust the striker bolt to get a tighter closing door. You loosen it and push it further back for a tighter fit or pull it out some for a looser fit. Hope this helps.

12
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Best bet is to buy a Chilton Repair manual

User Avatar

You can adjust your 2004 Ford F1 50 door with the retaining bolts on the door. Loosen the retaining bolts and the door will slide up or down.

User Avatar

how to fix a fuel door on a 2010 f150

User Avatar

Driverside bottom of the windshield, driverside door panel, and there may be on on the hood in the engine compartment

User Avatar

How do I locate the heater blend door actuator in a Ford f150 pickup

User Avatar

between the driverside door and the dashboard and under the hood on the driverside in a big black box

User Avatar

a round container with a house coming out of the bottom located under the driverside door parallel to the front driverside tire.

User Avatar

I've never seen one that needs adjustment, but you can loosen the hinge bolts and move it that way.

User Avatar

Yes, the 2001 Ford F150 driver's door will fit on the 2001 Ford Expedition.

User Avatar

The hinges on a 1992 Chevy S-10 are on the side. If any adjustments are needed for the door they can be made through there.

User Avatar

Adjust the length of the arm or move the door closer.

User Avatar

check your owners manual-driverside at horn. possibly driversside door & passengerside dash & door.

User Avatar

the fuel filter on a 1995 Chevy Tahoe should be located below the driverside front door just climb under the driverside door and look attached to the frame, easy to find and easy to change once you know where they are.

User Avatar

Adjust the stricker whichever way it need to go.

User Avatar

I believe its attached on the frame underneath the driverside door.

User Avatar

underneath the driverside door protected by a metal shroud

User Avatar

The fuel filter is uder the driverside door outside of the truck. Underneath the truck you will see the frame ( C-beams) of the truck. Its on the inside of the driverside C-beam.

User Avatar

yes, but they are slightly different. in 1995 & 96 Ford put a crease at the bottom of the door. this is strictly cosmetic and doesn't affect the functionality of the door.

User Avatar

How do you adjust the doors on a dodge ram truck 1500

User Avatar

i have a 10 ft by 10 ft atc roll up door. how do i adjust the spring tenson?

User Avatar

on the latch there are two small bolts loosen them and move the latch up then retighten

User Avatar

A few years ago an Andersen rep. adjusted my patio swing door and it is now sticking a little again. How can I adjust it? ktjkohler@arvig.net


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.