I think there is a plastic shroud covering the top of those headlamps. If you unscrew the plastic piece above the lamps you should see the adjusment screws The headlamps will only adjust vertical. When you open the hood and look down at the headlamp you will see one small bolt at the bottom corner of the lamp. Turn this to adjust the headlamps vertically. There is NO plastic piece to remove.
yes it can but you need to change te harness, do you have the concealed headlamps for sale or something?
The headlights on a 2004 Pontiac Montana are adjusted by turning the screws along the back and side of the headlight assembly. They control the horizontal and vertical movement of the headlights to allow for precise aiming.
you did not turn the switch off they are not automatic
were is my 1999 pontiac grand am map sensor location
I would suggest replacing it.
try replacing the starter
try replacing your battery maybe turn the key?
How is the ignition key switch replaced on the 2000 Pontiac Sunfire? And after replacing the switch would I have to have it Towed to the Pontiac Dealer in order to have the car key programed to the Computer?
May be coil pack
What kind of bearings??Engine, wheel, trans,diff.?????
It will run you $30-40 depending on part store.
The Pontiac Aztek has a chain which will last the life of the engine and should never need replacing until the engine is overhauled.
What it will cost you to replace the distributor cap on a Pontiac Sunfire will vary depending on if you do it yourself or if you take it to a garage. The cost can be over $100 if you take your car to a garage.
This is a vertical unit directly behind the water pump on the passenger side of the motor.
right above the head light under the hood are two star like bolts type thing, use a Torx Socket and extension to adjust the headlights, the adjuster closest to the fender controls the horizontal movement and the one closest tot the radiator controls the vertical movement
You should see a horizontal steel pipe just in front of the engine. This pipe has the bleeder screw.
Try cleaning or replacing the Idle air control sensor.
no. the entire thing needs to be replaced
"Replacing a power door lock on a 4door pont G6
yes mine had a really rough idle and it turns out the motor mount needed replacing
parts and labor should run around $650
by replacing the radio unless you are inclined towards successful and attractive African American re-engineering.