How do you adjust the headlights on a 1998 Toyota Sienna?
The 1998 Toyota headlight have two adjustment screws. There is an adjustment screw on the top and bottom of the headlight. Turn the screws to adjust the headlight.
How can you manually release the emergency brake on the 1998 Toyota Sienna?
The 1998 Toyota Sienna does not have an interference engine. This is what makes the engine to be quite sensitive as interference engine design is easier and safer to replace.Ê
How to replace 1998 Toyota corolla headlights
take it and the headlights to a dealer
You can find replacement radio knobs for a 1998 Toyota Sienna at auto part stores. You can also find replacements by contacting the radio manufacturer.
there isn't one
Where is the short at? What is malfunctioning?
The same question for a 99 Sienna was answered on this site by referencing www.findonefindall.com/toyota-sienna/ The price quoted for the handle way $65.
yes i have overdrive button
To adjust the headlights on a 1998 Volkswagen Jetta, use the vertical adjustment screw located off the top of the headlight compartment. There is also a lateral adjustment screw within the Jetta's headlight housing unit.
how much does it cost to replace the timing belt in a 1998 Toyota sienna.
The 3.0 liter V6 in a 1998 Toyota Sienna is a NON INTERFERENCE engine according to the Gates website ( they make timing belts etc. )
fix the vacuum leak
There are screws to adjust them just above the light assy.
must be a oxygen sensor
you dont........you buy a new car.....
Official: 100,000miles Non-official:200,000miles.
We have a fix for this problem that anyone can do - includes testimonials! http://www.findonefindall.com/toyota-sienna/index.htm See full details under "How do I replace the passenger side mirror on 2000 Toyota Sienna?
I don'y know
Under the hood, by the headlights casees (well, actually behind them), you should see two screws/knobs. One if for up/down movement, and the other is for left/right movement. A socketwrench works nicely to adjust the headlights.
According to the 1998 Toyota Sienna Users Manual the recommended tire sizes for the 1998 Sienna front wheel drive van are: P205/70R15 - Tire Pressure: 35 psi - Wheel Size: 15 x 6.5jj P215/65R15 - Tire Pressure: 32 psi - Wheel Size: 15 x 6.5jj Wheel Nut Torque 77 lbf
Its under the dash, there's a little ashtrey it's behind that On my 1998 Sienna XLE, the fuse box is in the engine compartment on the driver's side in a long black box
Visit siennaclub.org for detailed information.
only the bottom pan
change the wiper fluids, or get it checked out
Tools required are a 4mm socket to adjust the lamps with the bubble levels located on the headlamp assy.
It is nonadjustable. It is controlled by the computer.
I have a 1998 sienna w/160,000 miles. Original owner. I get about 20 around town and 25 or better on highway driving.
The spare tire release bolt is located in the rear cargo area of the 1998 Toyota Sienna. Look for a small "U" shaped piece of loose carpet on the floor of the cargo area. The bolt should be turned counterclockwise to release the spare tire.
Adjusting the steering wheel on a 1998 Toyota Corolla is easy. All you have to is find the latch at the bottom and push in to adjust the wheel.
NOTHING lasts forever. Except bad credit
Follow the plug wires and find the plugs. Sometimes the plugs can be hard to get out.
I'm getting about 18 city and 25 hwy on a 98 with 150000 miles.
There are adjustinf screws on the top and sides of the lights. I like to get on a country road at night and adjust them like I want them, careful not to blind oncomming drivers.
You dont adjust the Idle disconnect the battery for 10 mins and reconnect and the computer should relearn it idle .
1998 - 2001 year models firing order 1-2-3-4-5-6
You should be able to go to the dealer and get one made from the VIN, vehicle identification number.
Trouble code P0150 means:O2 sensor circuit malfunction (Bank 2 Sensor 1)
The fuse box is located under the hood to the right of the engine. It's in a black box.
You need to check the wiring around headlights, fuses and the bulbs.
pull a little harder than you did last time on my Toyota sienna 2001 it just slowly popped out so don't worry worst you can break is a couple plastic clips that you can buy almost anywhere just man up and pull a little....
2 Phillips screws at the rear of the headlight housing. One is vertical the other horizontal.
Trouble code P0153 means:O2 sensor circuit slow response (Bank 2 Sensor 1)
It is impossible. Buy a new one. Don't waste your time! I found a good fix @ http://www.findonefindall.com/toyota-sienna/ Please contact Toyota (phone number in your owner manual) to document this defect, the more complaints they receive, the better the chance of a recall. A more complete URL to the page referenced in the second answer is ... http://www.findonefindall.com/toyota-sienna/siennareardoor.htm I used that successfully to repair the broken rear door latch on my 2000 Toyota Sienna. ("Buy… Read More
remove the glove box by taking out the screws facing you. then pull it down
Toyota uses shims to adjust valves. Basically you have to remove the valve, take out the shim measure compare with what it's supposed to be. If it's too short replace with the right height. One shim costs about $8-10 at Toyota dealers. You can get it only from dealers.
Disconect the - battery cable Raise and support vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter
The headlights on a 1998 Honda Civic use adjustment screws which are located on the side of each headlight in the engine bay. Tightening it will raise the light and loosening it will lower it.
If you replace the power mirror on a 1998 Toyota Sienna LE with a heated power mirror will the heat feature work?
Highly doubtful because the circuit has to be there to power up the heater in the mirror.