You can not adjust the idle screw, it is sealed off at the factory. If you are having a high idle problem check for a vacuum leak or a bad idle air control valve. These will commonly cause a high idle.
Remove the water supply hose from your 1988 Chevy Cavalier thermostat housing. Remove the thermostat housing bolts. Lift the old thermostat out and drop in the new thermostat.
how do you set timing on 88 s10 2.5? ?
Remove the wiring harness from your 1988 Chevy Cavalier fuel pump. Remove the fuel lines from the fuel pump. Remove the fuel pump retaining bolts. Reverse the process to install the new fuel pump.
There is no choke to adjust.
Yes, I have a 1988 and 1989 Chevy Cavalier Z24 and they both have the 2.8L V6
CW.
1988 chevy cavalier flasher take ash tray and bracket out look up and lift you can see it if not you can put your hand up in to lift and find it.
To adjust the valves on a Chevy Celebrity 2.5L 4 cylinder engine I would recommend that you consult a manual, either factory or Chilton or Haynes. There you will find not only how to do the adjustment but the settings to use to adjust the valves in the correct closed position.
Firing order 1-3-4-2 --- front | 1 | | 2 | of | 3 | vehicle | 4 | --- distributorless ignition
Go to www.autozone.com, enter all your vehicles info and then navigate into there troubleshouting and help section. it will show you a diagram.
1-6-5-4-3-2- good luck ......chevy boy
synchromesh its a dealer only fluid.