you can't unless you have the computer to plug in the diagnosis port...it's all controled via the ecm!!!
You cannot. As it is EFI, therefore controlled electronically, you would need to plug it into a diagnostic computer to access the idle speeds etc.
If it is throtle body equipped, the idle control s solonoid controls it. If it has a carb there is an adjustment screw on the bottom of the carb.
how do you adjust the idle on a 2002 toyota van
you can adjust it via the idle control valve.
It is on the throtle body.
The idle adjust screw is on the throttle body. The side of the throttle body that faces the front of the car should have a dime size flathead screw towards the upper edge.
You dont adjust the Idle disconnect the battery for 10 mins and reconnect and the computer should relearn it idle .
yes u can I've done it but i have a high idle issue if the car is in park or neutral.
smash it into the wall
How do yu adjust idle in a nissan sentra
It is nonadjustable. It is controlled by the computer.
How do I adjust the idle on a 1994 Dodge Caravan?
Computer controlled - not adjustable
the TPS (throttle position sensor) controls the idle.
there is an Allen screw and a nut on the throttle cable you loosen the nut and the screw and adjust it to make it idle up or down.
There are a number of reasons why a 1991 Toyota Corolla engine would stop running after startup. It could the idle control, an EGR leak, or low fuel pressure.Ê
bad engine mounts low rpm old timing belt over charged ac
Hey JustinThe idle speed is controled by the ecm and is not adjustable. Goodluck, Joe You can adjust the idle air screw. Get a haynes manual it will show you how
May be computer controlled and not adjustable
You can't adjust it, you have to replace either the IAC ( idle air control ) sensor or the TPS ( throttle position sensor ) to fix a bad idle.
Ticking on acceleration is usually the ignition timing, get it tuned..
Ignition Timing Initial/Static: 8@Idle C/S
You don't. The ECM (Engine Control Module) maintains the correct idle speed. If the idle is out of control you probably have a vacuum leak.
According to the Haynes manual, it is not adjustable.
You adjust idle with idle timing