YOU DONT: YOU PROB NEED A NEW TENSIONER
Computer controlled If you have a 3.0 you can turn the distributor to adjust, after you pull out the adjustment chip.
No. You need to replace the tensioner.
No you can not. You need to replace the tensioner.
Yes, it is used to adjust the tension on the A/C compressor. Looking into the engine compartment from the passenger side it is to the left of the alternator. To adjust tension you need to loosen the bolt which holds the pulley and then adjust the bolt which is directly above the pulley. Once you have proper tension tighten the pulley bolt.
What tension bolt? There are many bolts under tension.
The 3.0 and the 3.8 liter V6 engines in a 1994 Ford Taurus are fuel injected , so there is no carburetor
On a 1994 Ford Taurus : The 3.0 and 3.8 liter V6 engines use a timing CHAIN
Controlled by on board computer, not adjustable. But look for vacuum lines that may be damaged, cracked, or unhooked- that will greatly affect idle.
In a 1994 Ford Taurus : Both the 3.0 and 3.8 litre V6 engines have a timing CHAIN
No - way too many changes made to the Taurus between the 2 model years.
GL= Grand Luxe (Luxury ver of Taurus)
Maybe the information for a 1998 Sable/Taurus in the "Related Question" below will help with your 1994.Should be very similar
How do you adjust the steering gear box on a 1994 Ford F150 Econoline van.
no,the 96 is electronically controlled,the other trans is not
The price of a fuel filter on a 1994 Ford Taurus
On a 1994 Ford Taurus , V6 : firewall 1-----2-----3 4-----5-----6 front of vehicle
For a 1994 Ford Taurus GL : The base engine was the 3.0 litre " Vulcan " V6 engine The optional engine was the 3.8 litre V6
how to adjust cluch for a 1987 bayou
with a screwdriver
my 92 is in the trunk.
It only has one.
cars as new as the 1994 Ford Taurus had to be ordered with lighters and ash trays.i'm thinking you have one that does not have either. In the ashtray in center of dash under radio.
Yes it will fit all models of Taurus.