Nissan 300ZX

How do you adjust the timing and idle speed on a 1993 300zx non-turbo?

171819

Top Answer
User Avatar
Wiki User
2016-12-18 17:18:36
2016-12-18 17:18:36

Do it the old school way and just let the car idle and adjust your CAS until you hear and knock and then go back the other way until you hear a ping, then do it until you hear nothing. Lock it down and be on your way.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

There is a idle screw on the throttle linkage on the carb that you can turn to increase the idle speed and then hook up your timing light to check the timing.

User Avatar

1989 supra turbo 5 speed is = to 1985 300zx turbo 5 speed?

User Avatar

You cannot adjust it and it is set by the computer in the car, it can vary by altitude, speed and accelleration.

User Avatar

Answerit's mounted on the front of the right distributorkap'90-'96 300zx had a Coil-On-Plug design.(thus no distributor)The ICM is located on the passenger side timing belt cover. underneath the intake pipe/throttle body piping.Vehicle Used for reference: 1990 300zx (n/a 5-speed)

User Avatar

You shouldn't. The idle speed is set at the fatory. Instead look into testing your TPS and VAM. Check timing and and test O2 sensor.

User Avatar

You can adjust your speed and go as fast as 120 steps a minute on this machine!

User Avatar

On the floor to the left of the driver's seat, there's an input into which a handheld computer is plugged in to adjust the engine controls. You need that computer to adjust your speed settiings.

User Avatar

How do you adjust the idle speed on a citroen berlingo 1.9d (basic diesel engine)

User Avatar

replace the plugs and wires, get a new distributor cap and rotor and replace the points and set them, next adjust the timing and finally adjust the air and fuel mixture on the carburetor and set the idle speed.

User Avatar

you can adjust it via the idle control valve.

User Avatar

there is a set screw on the linkage on the carb that will adjust it.

User Avatar

you can`t adjust the idle speed manualy,it has to be done through the ecu via a main dealer diagnostic computer.

User Avatar

The ECU has a cruise control speed limiter that will not allow the cruise control to be set after that speed has been exceeded.

User Avatar

Yes, They normally adjust timing and air/fuel ( like in the old days recurving distributor and rejetting the carb). They also can remove speed limiters, raise redline/fuel cut-off, and adjust boost on some vehicles.

User Avatar

Is rad fan coming on? It has 2 temp sensors one for gauge light and one for comp. If one for comp isn't working and telling comp motor is cold it will be dumping extra fuel thru cold start injector I changed the sensor for the computer and it was the problem. Took a while to change it because its in a tight space

User Avatar

My engine is idling too high. How do I adjust the idle speed?

User Avatar

Computer needs to re-learn the idle. Spark plugs are bad. Valves are not properly gapped. Adjust Idle Speed on Throttle body.

User Avatar

There is nothing adjustable about a 5 speed trans.

User Avatar

Both the speed and the grade of incline are adjustable on this treadmill.

User Avatar

dont know what you want to adjust? speed? depth? indicator light?

User Avatar

All spec's including speed can be found here http://www.cargurus.com/

User Avatar

You do not, this is regulated by the ECM.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.