How do you bleed a clutch in a 93 Chevy Blazer?
it takes 2 people,1 to pump the clutch pedal and the other to bleed it from underneath at the clutch slave cyl. but remember to keep the reservoir full at all time. it is kind of like bleeding the brakes on your car
There is no adjustment, The clutch it self is either worn out, Bad clutch slave cylinder. Air are no fluid in the clutch mastercylinder. Fill clutch master cylinder up with fluid, be sure to remove the little rubber cub that is inside of the clutch master cylinder before you fill it up, then bleed the clutch of all air. Then see if the clutch works better.
How do you adjust the clutch pedal to make a 93 Ford Probe GT go in gear after installing a new clutch and slave cylinder?
1. Remove the rubber cup from the bleed valve on the slave cylinder and fit a clear vinyl tube over the bleed valve and put the end in a container of brake fluid. 2. Have someone pump the clutch slowly several times and then hold it down. 3. Loosen the bleed valve to let the air escape. When air quits flowing out of the vinyl tube in the container of brake fluid close the valve…