answersLogoWhite
Heating AC and Engine Cooling
Antifreeze and Engine Coolant
Radiators
Chevy Monte Carlo

How do you bleed a cooling system in a 1999 Monte Carlo Z34?

555657

Top Answer
User Avatar
Wiki User
2015-07-15 21:36:42
2015-07-15 21:36:42

There are instructions in the manual. Take off the top cover and locate the bleeder screw, directly over the Thermostat. Loosen the screw. Add coolant to the radiator with cap off till full. Start the engine. When there is water coming from the bleeder screw, then wait a bit and tighten it . Add a little more coolant to the radiator and then put the cap back on.

1

Related Questions

User Avatar

Any time you flush out the cooling system you need to bleed the cooling system.

User Avatar

how to bleed air out of cooling system 1997honda civic ex

User Avatar

how do you bleed a diesel peugeot cooling system

User Avatar

Same as you would without ABS. Bench bleed the master, install master, bleed system, keep reservoir full during process.

User Avatar

How do you bleed the cooling system of a 1988 acura legend? Is there a bleeding screw and where is it located?

User Avatar

If the cooling system is in good working order the system will bleed the air out itself. If the system has a leak anywhere no matter how small the system will never bleed the air out.

User Avatar

You bleed the brakes just like you bleed any other cars brakes, there is no special way to bleed anti-lock brakes.

User Avatar

there should be a air valve on the engine that you can bleed the bubbles out of the cooling system.

User Avatar

Orange. Make sure to bleed out the air if you are filling the radiator.

User Avatar

you have to bleed the system it sounds like it has air in it so you need to locate the bleed screw which is normally on the thermostat housing

User Avatar

Engine cooling system is not a closed system you can't remove the air.

User Avatar

The cooling system bleed valve, on your General Motors 5.7 liter engine, is located on the bottom of the radiator. The bleed valve should be in the middle of the radiator bottom.

User Avatar

There are various ways to bleed air from Clio cooling system. The best option is to run the system for a while with the cap up while making increased revs. Ê

User Avatar

The bleed screw is by the thermostat housing it looks like a brake bleed screw

User Avatar

how does engine cooling system on berlingo 1.4 work

User Avatar

you dont bleed cooling systems you have to take it to a mech. shop or have the proper equipment and the r-134a on hand to do it your self.

User Avatar

There is no need to do this normally.

User Avatar

Should bleed all vehicles after the system has work done to it to get rid of air pockets

User Avatar

To bleed the cooling system on a 96 Acura 3.5 L, cool the radiator and remove the radiator cap. Loosen the drain plug and drain.

User Avatar

drain the whole cooling system and refill it. You will never know if you don't give details of your car!

User Avatar

To bleed the cooling system on a 1996 Olds Cutlass, locate the bleed valve, which is on the front of the engine above the water pump. After making sure the cooling system is not under pressure, open the valve by turning it counterclockwise. Fill the radiator with coolant until no air comes out the bleed valve, and a stream of coolant begins to flow from there instead. Tighten the valve and close the system to finish the job.

User Avatar

Bleed valve is located on top of thermostat housing.

User Avatar

how do you bleed air out of a 300 tdi discovery landrover


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.