answersLogoWhite

0


Best Answer

The same way you would for brakes. Pump the clutch 4 or 5 time and hold down then open the bleeder valve to release the air. Is it the 2.8L V6 motor?

User Avatar

Wiki User

โˆ™ 2010-08-06 04:37:22
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you bleed the clutch on a 1983 Chevy s10 blazer?
Write your answer...
Submit
Related questions

How do you bleed a clutch on a 1983 Chevy s-10?

As i believe, from experience of owning one, 1984 is when the hydraulic clutch came into place. You shouldn't need to bleed the clutch on an 83' S10. Not unless its not the stock transmission.


Where is the ignition control module located an a 1983 Chevy blazer?

Where is the control module located on the 1983 Chevy blazer


Can a 1983 Chevy blazer run on E85 fuel?

NO!


Does a 1983 Chevy Blazer have a clutch fluid port?

There is a reservoir for the hydraulic clutch under the hood , driver side just above the brake master cylinder reservoir. The clutch also has a bleeder valve on the driver side of the clutch bell housing. full size K5 blazer in 83 does not have hydraulic clutch. small little s-10 blazer does possibly, in 83 but may not until 85 also., you need to know which blazer you have, little one or big one they are TOTALLY different trucks., there was no hydraulic clutch in the full size trucks until 85, including the K5 blazer


What is gross vehicle weight of Chevy blazer 2 door 4x4?

The gross weight for a Chevy Blazer 2 door 4x4 is 5300 pounds. The Chevy Blazer was produced from 1983 to 2005.


Wiring diagram 1983 Blazer?

The wiring diagram for a 1983 Chevy Blazer can be found in the service manual. It contains a detailed layout of where each wire goes and its function.


What kind of transmission fluid and how much for a Chevy 1983 blazer S-10 take?

A 1983 Chevy Blazer transmission will hold 12 quarts of transmission fluid. The manufacturer recommends using a. SEA certified transmission fluid.


What door latches are universal for a 1989 Chevy s10?

Any 1983 - 1993 S10, and 1983 - 1994 Blazer, Jimmy, or Bravada.


Why makes a 1983 Chevy S10 Blazer 2.8 V6 stall when the accelerator pedal is depressed?

Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.


How do you adjust clutch on a 1983 k20 Chevy pickup?

There is NO adjustment. It is adjusted automatically through the hydraulic slave cylinder. Probley time for a NEW clutch kit.


What are the release dates for Mazer Blazer - 1983 VG?

Mazer Blazer - 1983 VG was released on: USA: 1983


Do you have to go in reverse to take a 1983 Chevy s 10 blazer out of four wheel drive?

If things are worn alittle It helps to get it out of 4x4


What size windshield wiper blades for a 1983-1994 Chevy S-10 blazer?

The 1983-1994 Chevrolet Blazer S-10 (sometimes called "Compact Blazer") takes 16" replacement windshield wiper blades on both sides front. The 1989-1994 models also take a 14" rear wiper blade.


Where is the headlight fuse for a 1983 Chevy S-10 blazer?

Back then the headlight circuit was protected by a circuit breaker that was built into the headlight switch.


Where can you get a vacuum diagram for a 1983 Chevy Blazer?

You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.


Fuse diagram for a 1983 K5 Blazer?

A fuse diagram for a 1983 K5 Blazer is helpful for mechanics that need to make repairs on the car. The diagram can show the mechanic where exactly the parts are for the Blazer.


What vehicle is interchangable with 1983 Chevy s10?

90% of the parts from any 1982 to 1993 Chevy S-10 or GMC S-15 (Sonoma). 85% of the parts from any 1982 to 1993 Chevy S-10 Blazer, or S-15 Jimmy


What model Chevy truck in 1983 weighs less than a 1983 Chevy C10?

The Chevy Luv


Why is my clutch pedal stuck to floor after installing new clutch master cylinder on a 1983 Nissan truck?

u must bleed the system . fill the clutch master cylinder with dot 3 brake fluid and keep an eye on it when bleeding so it wont run out ,have someone pump clutch pedal 3 times and hold to floor and oper bleeder valve on clutch slave cylinder till no air comes out then go to clutch damper and do the same ,follow clutch line fromclutch master cylinderto damper.


How much is a 1983 Chevy truck worth?

How much is a 1983 chevy truck worth?


What do you do when a choke light comes on and of in 1983 Chevy?

There is no choke light in a 1983 chevy, no matter what model you have.


Where can i find 1983 Chevrolet blazer reviews?

google it on the net


What years did gm produce the s10 blazer?

1983 to 2005.


Will a 1983 Chevy suburban power steering gear box fit a 1983 Chevy truck?

Yes it will.


What other Chevy have a 5x4.75 bolt pattern?

1983 to 04 S-10, S-15 BLAZER, JIMMY, SONOMA,1955 to 1988 Chevrolet/GMC ALL MID & FULL SIZE RWD,