I HAD THE SAME PROBLEM WITH MY 92 WRANGLER.. GO TO AUTOZONE.COM AND CLICK ON SERVICE MANUALS, THEY WILL EXPLAIN HOW TO BLEED THE SLAVE CYLINDER.. AND IT WORKS.. DON DRC@EPIX.NET
Dot 3 brake fluid
How to change a clutch and master cylinder on a 93 jeep wrangler
Bench bleed it to avoid introducing air into the system.
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
A 2002 Wrangler has a non adjustable hydraulic clutch.
The clutch is not adjustable.
Right above the slave cylinder there is a bleeder screw. Just unsrew it and have someone hold in the clutch to start the bleed.
It sure sounds like your clutch is done
They didn't make a 1996 Wrangler...
the same as any other clutch.
It is not adjustable.
On the opposite side of the trans from where the clutch line enters, a fitting with a bleed valve on the end. You can get a great view if you remove the access panel around the shifter, you will be able to see them both from there, loosen the end to bleed.
you cannot adjust you need new clutch.
This should have a hydraulic clutch and would not be adjustable
You may have to have your clutch adjusted,
No.The clutch is hydraulic and not adjustable.
The correct factory tire size for a 1992 Jeep Wrangler is 215/75R15.
Mt jeep wrangler has a dana 35 differential in it