answersLogoWhite

0


Best Answer

it's the same as bleeding the brakes. find the bleeder screw by the slave piston housing. open it have someone step on the clutch for you. just keep an eye on the reservoir because since its so tiny the fluid will empty faster than on the brake system.

User Avatar

Wiki User

โˆ™ 2007-12-07 21:35:49
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you bleed the clutch on a 1994 Chevy Beretta?
Write your answer...
Submit
Related questions

Where is the freeze plug on a 91' Chevy beretta gt?

i have a 1994 Chevy beretta and they are under the engine


What size alternator for a 1994 Chevy beretta?

A 1994 Chevrolet Beretta with the 2.2 or the 3.1 engine takes a 105 amp alternator.


Where is the horn on a 1994 z26 Chevy beretta?

On the steering wheel.


Where is a 94 Chevy beretta z26 voltage regulator?

The regulator on a 1994 Chevy is inside the alternator.


What was the original sticker price on the 1994 Chevy Beretta Z26?

about $15,500


Change a brake cylinder 1994 Chevy beretta?

go to a repair shop


Where is the oil pan located on a 1994 Chevy beretta?

Underneath the engine block.


How can you install the front shocks on a 1994 Chevy beretta z26?

There are no front shocks on any Beretta. Shocks are in the rear. Struts are in the front.


How do you replace the oil pump on a 1994 Chevy beretta?

Remove engine oil pan


What oil type in a 1994 Chevy beretta?

Read what it says on the OIL filler cap....


How do you bleed the power assisted clutch on a 1994 ford escort wagon?

Thru the bleed valve on the slave cylinder attached to the transmission.


How do you replace the complete wiring harness in a 1994 Chevy beretta?

Bstuff.com should have the info you are looking for.


What is the torque spec for a 1994 Chevy beretta wheel bearing nut?

184 ft lbs


Does the 1994 Chevy Beretta have AC?

yes it does. the controles are usually mounted right under the radio.


Removing the engine from a 1994 Chevy Beretta- does it come out the top or the bottom of the car?

It comes out the top.


Where is the thermostat on a 1994 Chevy Beretta 3.1 z26 and how do you replace it?

The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.


What could cause a 1994 Chevy beretta not to start?

bad fuel pump, bad ignition, ecm wires removed, clutch safety switch, about a million things -berettaspeed15 bad fuel pump, bad ignition, ecm wires removed, clutch safety switch, about a million things -berettaspeed15


Where are the senors for air conditioner on 1994 Chevy bretta?

air conditioner for1994 Chevy Beretta not working is there a senor that could be bad. system is charged.


Where is the fuel filter located in your 1994 Chevy Beretta?

5/8 and 3/4 open end wrenches


How do you recharge the air conditioner on a 1994 Chevy beretta?

Buy a kit at Wal-Mart or auto parts comes with instructions


Where can you find a spark plug wiring diagram for a 1994 Chevy Beretta?

Your local libarary in a motors manual or Clinton motors


How do you replace the ignition switch in a 1994 Chevy Beretta?

about 18 other people asked this question go look at those


How to tell if abs brake pump is bad on 1994 Chevy beretta?

it is a 1995 Chevy blazer and it will not go into park. have to use the emergency brake when stopped, and neutral to start it


Where is the clutch slave cylinder located on a 1994 Chevy Camaro?

should be located on the bell housing


When was Beretta's Island created?

Beretta's Island was created in 1994.