0
While the bleeder valve is open on the slave cylinder, you will have to push back on the shift fork with a prybar. This will allow you to get the air out of the system. Make sure you have somebody holding the pedal down while bleeding and checking the fluid level, since the master cylinder does not hold a lot of fluid.
answer
THE VERY MAIN THING IS MAKE SURE FLUID PIPE LINES ON BOTH ARE VERY TIGHT AND INSTALLED RIGHT WAY,THE REASON FOR THAT IS YOU JUST NEED TO BLEED THEM ONCE,GRAVITY BLEED OR VACUUM BLEED
Add your answer:
Earn +20 pts
How do you adjust clutch on 92 rodeo?
There is not any adjustment on this clutch. Al you have to do is bleed the system.
How do you bleed hydraulic clutch 92 rodeo?
pray like hell
How do you replace the clutch slave cylinder on a 1997 Isuzu Rodeo?
take the cap off and roll another rodeo under it
When did they stop making the Isuzu Rodeo?
The last Isuzu Rodeo was in 2004.
On a 1990 Isuzu Amigo what would cause the clutch pedal to stick to the floor?
if its hydraulic there could be air in your line. bleed your clutch and refill.
Will a 1999 Isuzu Rodeo headlight work on a 2001 Isuzu Rodeo?
Yes
Will a 1993 Isuzu Rodeo windshield fit a 1996 Isuzu Rodeo?
Yes.
How to Adjust the parking brake on an Isuzu rodeo?
adjusting Isuzu rodeo brakes
Timing diagram Isuzu rodeo?
what is the cam diagram for Isuzu rodeo 1998 2.2
How do you pull codes on a 93 Isuzu rodeo?
Pull codes for 2001 isuzu rodeo
What is the transmission fluid for a 1996 Isuzu Rodeo?
how do you find out how to check the transmition in a isuzu rodeo
Where is the fuel filter located in a 1997 Isuzu Rodeo?
Where is my filter for my 97 ISUZU RODEO
