pump the clutch pedal several times it should fix your problem
As i believe, from experience of owning one, 1984 is when the hydraulic clutch came into place. You shouldn't need to bleed the clutch on an 83' S10. Not unless its not the stock transmission.
bleed it the same way u would bleed the brakes the bleeder is on the driver side of the trans on the bell housing
Bleed the clutch. Same way you would bleed you brakes.
bleed clutch Saturn vue 2003
The same way you would for brakes. Pump the clutch 4 or 5 time and hold down then open the bleeder valve to release the air. Is it the 2.8L V6 motor?
there dry clutch's, run a cable. no fluid. .:. you can't bleed it. :)
where and how to adjust clutch pedal 1993 s10 It is hydraulic operated, there is no adjustment.
how do I bleed the clutch system in a 2004 ford ranger
after the clutch master cylinder has been replaced.
The clutch can't be adjusted. It is an hydraulic clutch. The clutch pedal sends pressure from the master cylinder to the slave cylinder on the clutch. IF you are having trouble with it the thing to do is bleed the air out at the slave cylinder. Have an assistant pump the clutch and hold it to the floor. Then open the bleed valve on the slave cylinder to let the air out of the system. On the final bleed hold the clutch to the floor and close the bleed valve on the slave cylinder. The clutch master cylinder operates of the brake fluid reservoir. Make sure you keep this full of brake fluid as you bleed the clutch.
To bleed a clutch on a Nissan Stanza, you need to find the bleed-off valve, usually somewhere near the slave cylinder.
It doesn't have a clutch cable. The clutch is hydraulically operated.