0
It is definitely not a good idea to bypass the sensor. If you have the 22re engine, then replacing the sensor or the wiring is trivial. Not so on the 3vze. The sensor is located under the upper and lower intake. So, for a quick bypass you can buy a new sensor and attach it to one of the engine mounts (there should be one on the drivers side, a couple of inches from the wiring harness). You can either drill through the mount, or bolt the sensor inside the loop of the hook.
Note, this is a very temporary "fix". In this location, the sensor will not be able to perform its job. Be warned!
What else can I help you with?
Toyota 95 4runner code flashing dtc52 knock sensor?
where is the nock sensor on my 95 toyota 4runner
Where is the engine knock sensor on a 1990 Toyota 4runner?
It is in the trough below the EGR and intake manifold alongside the water bypass tube. Be careful with it if you take it out as they appear to be expensive.
Where is the knock sensor located on a 1995 Toyota 4runner?
its located under the head on the drivers side you can buy the wire separate 25 bucks the head has to be removed
Where is the knock sensor located on an 1998 4runner?
it located under the transmission
Where is knock sensor on 95 5.0?
where is the knock sensor on a 95 Toyota t100 v6
Can knock sensor of 2011 Chevy Suburban can be bypass?
yes
How much labor to change knock sensor?
how much does it cost for labor to change a knock sensor in a 2002 toyota siennna van
Where is the knock sensor for a 2001 Toyota Camry?
Knock sensor is attached to the engine side facing the firewall. It's not easy to reach.
Where is the knock sensor located on a Toyota 22re?
engine bay
Toyota Celica knock sensor location?
The manufacturer states throttle body and the intake manifold must be removed to access the knock sensor. The knock sensor is located on side of cylinder block.
How do you fix the knock sensor problem on a 1992 Nissan 300ZX or should you bypass it and how?
The Nissan gurus put the knock sensor on the car for a reason. Unfortunately it uses the engine block for the ground and only one wire of the two in the harness is live. The knock sensor is not the easiest piece of equipment to get to so many people either live with the knock sensor being bad or bypass it. Once you get to the sensor, you can clean the engine block and the bottom of the sensor and reinstall. That cures the problem in many cases. The most effective safe way to fix the knock sensor is to replace it. If you want to take your chances you can research knock sensor bypass in your favorite search engine. There are a lot of articles with step by step directions so I doubt the procedure needs to be repeated here.
Where can you find the location of knock sensor in a 1992 Toyota Cressida?
If you have the 7MGE engine: Then the knock sensor is screwed into the engine block, directly underneath the intake manifold.
