Chevy Camaro

How do you bypass the ignition switch on a 1987 Camaro to start the car?

678

Top Answer
User Avatar
Wiki User
2008-03-16 04:14:51
2008-03-16 04:14:51

Hi Ed, The normal way to hot wire an auto ignition, has always been to clip a wire to the positive-post on the battery and then run the lead to the positive-post on the ignition-coil. Then, if you have a remote starter switch, simply crank the engine and it will start. If you do not have a remote starter switch, take a short screw-driver, (or something metal), and cross the two posts on the starter solenoid and crank the engine to start. To shut the ignition hotwire off, simply disconnect at the battery. Thats the simple and easy way. Of course, if you're gonna really fix the thing, you'll need to get into the main ignition switch, etc, etc,...understand? Hot-wireing is just a short term thing! Also, make sure you have the proper AUTHORITY to do all of this!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Check the 92 Camaro neutral safety switch next. If the switch is faulty then the starter will not get power to start the engine.

User Avatar

my 92 camaro is fitted with the anti theft device i changed the ignition switch and the car will not start need codes what are they??

User Avatar

You don't. The ignition is required to start the car. If it fails you need a new ignition switch.

User Avatar

how can you start a '89 mercury cougar with a broken ignition switch?

User Avatar

it should be defective ignition switch...................It could be anything between the ignition switch and the terminal on the starter solenoid. There may be a bad ignition switch, bad ignition fuse or a bad fuseable link.

User Avatar

The ignition switch is where you insert your key to start car

User Avatar

Yes to bypass,Press on the brake, turn car to as then on let the carburetor fill then, put the car in neutral,then start. If the security light is flashing, the car will not start for 10 minutes. Do not try to start while light is flashing.

User Avatar

when you start the car up that's your ignition switch is located...

User Avatar

my ignition is broke and on the on position how can i bypass the ignition n use a toggle for power and a pushbutton to start run thik power wire from positive of battery to starter. then wire from starter to distributer. then run wire inside or vehicle to push start and ground it or run back out to battery to neg. put toggle switch some where in the process to kill it.

User Avatar

The ignition switch is in the steering column..that's where you insert the key to start the vehicle.

User Avatar

Defective Starter solenoid or ignition switch. Ignition switch is bad.

User Avatar

The KILL switch is in series with the ignition switch. When the KILL switch is open, the bike will not start.

User Avatar

might be something with starter/solenoid assembly or the crank wire circuit coming from the ignition switch.

User Avatar

The ignition switch is one unit and you replace the entire thing. Do not confuse the ignition switch with the key lock tumbler. They are two different things.

User Avatar

check the vats on your key and the ignition switch. anti theft devise goes the security light comes on in the dash

User Avatar

For most cars, the sequence is... Off, ACC, Ignition On, Start

User Avatar

No, if it starts on its own without you turning the ignition switch then the ignition switch is defective.

User Avatar

if the battery is dead the switch wont unlock or start

User Avatar

an ignition switch or starter is a switch that activates the main electrical systems of a vehicle. This normally powers the start motor that turns the engine in the starting up process. . Most vehicles do not have an ignition switch anymore the key in the cylinder acts as the "switch"

User Avatar

If the switch fails, however, you won't be able to start your vehicle

User Avatar

Access the ignition switch through the faceplate covering the radio, and look for a small 3 piece set of wires on top of the ignition switch, and start the car as normal, having the anti-theft light "not" come on, and cut the little yellow wire and the anti-theft light will come on now, and stay on forever, but the car will always start.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.