Clutches and Flywheels
Nissan 300ZX
Toyota T100
Honda Accord LX

How do you bypass the neutral safety switch on a 1988 Nissan 300zx using a jumper wire?

323334

Top Answer
User Avatar
Wiki User
2006-01-27 04:25:48
2006-01-27 04:25:48

dont....just replace it..its safer........

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

To bypass the cars neutral safety switch, you need to find the two wires to the safety switch and connect them together. It can also be done by putting the car in neutral.

User Avatar

Where is the neutral safety switch on a 1994 Nissan Altima?

User Avatar

How do u bypass the neutral safety switch in a 2002 chevy silverado 1500

User Avatar

The 1993 Nissan neutral safety switch can be found on the left-hand side of the transmission. The neutral safety switch will be near the front of the transmission.

User Avatar

How do you change the neutral switch on a 1994 Nissan Quest

User Avatar

can you by pass a safety neutral switch on a 2001 dodge neon

User Avatar

Not a good idea. It is called a safety switch for a reason.

User Avatar

You do not bypass a neutral safety switch.It is critical to the operation of the vehicle.Spend the $25 to buy a new one - then follow the instructions in the "Related Questions" below to replace it.

User Avatar

It is built into the PRNDL switch on most cars and impossible to bypass.

User Avatar

It doesn't have one, it has a switch on the clutch pedal. It also has an interlock switch on the dash, turn the ignition switch on and press the interlock switch and it will bypass the clutch switch.

User Avatar

I don't think anyone can help you with this one. If I'm not mistaken it's illegal to bypass the neutral safety switch if it is equipped on the car. Is there a reason you need it disabled? Is it broke? Trail only vehicle?

User Avatar

Need to know if it is standard or automatic and why.

User Avatar

find the conector(s) and jump it. also try starting your vehicle in neutral.

User Avatar

Turn the key to the "On" position, jump the two posts on the starter solenoid.. you might be able to do this with a screwdriver, or with test leads, a piece of wire, etc. Make good and sure that the car actually is in neutral before you do this.

User Avatar

You shouldn't even think of doing that. Just replace the switch.

User Avatar

To override a neutral safety switch, locate it (it should be at the base of the steering column) and remove the green and brown wire. Connecting these two wires together will bypass the safety switch and your reverse lights will turn on.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.