there are plastic covers over them on the inside of the trunk that you pop off
how do you change the light bulb over the license plate on 2000 eclipse
Open the turn there is a little hatch take it off twist the light out and pull the bulb put the new one in simple.
You have to remove the interior trim of the lift gate.
If the light stays on when the emergency brake is not engaged, this indicates the brakes are getting low and need to be replaced.
on the second generation eclipses it is located at the fulcrum of the arm assembly for the brake pedal.
If you want to change the light you have to remove the right rear internal panel (located in the trunk). Only after removing the panel you will gain access to the light. Then it's just matter of removing nuts replacing the light and putting everything together.
Replace the bulb it works when you turn on the driving lights and when you brake. there are two little springs inside the light one is for the brake light and the other is for the driving light. All you need to do is replace the bulb. good luck.
in the fuse box! read your manual! when replacing make sure you replace the fuse with one of equal amperage (amps)
The parking brake light stay lit on the 1999 Mitsubishi Montero sport the parking brake is working and you have not put the light off.
Inside the trunk behind where the brake lights are are a plastic cover. Remove that and you will see one bolt. Reach in to the far side of the light and you will find the second bolt. Remove those and the brake lights can be pulled out. Now just twist the bulb holders and there are your brake light bulbs.
You have to take the whole light assembly off by going through the trunk. There is a panel the snaps off the wall of your trunk. In there are a few nuts I believe are 10M that you will take off and the assembly will pull away from your car.
afshar13@yahoo.com