The tranny ( or transaxle / transmission ) on a 1993 Mercury Tracer is in the engine compartment bolted to the engine on the drivers side of the engine
The fuel pump on a 1993 Mercury is inside the fuel tank.
as much as it takes to fill it up dummy
go to a junk yard
The gap should be .052-.056
NEED COLOR CODE FOR RADIO SPEAKER WIRE 93 MERCURY
There is none. It is electronic. Try replacing the idle motor.
how do you change a water pump on 1993 Mercury Cougar
Overload or short to ground
It is 1-3-4-2.
Perhaps the part of the headlight bulb has burned out.
The 1.9 liter and 1.8 liter four cylinder engines used in the 1993 Mercury Tracer are NON - INTERFERENCE engines according to the Gates website ( they make timing belts etcetera )
In the cylinder head (top part of motor under valve cover).
ITs your Starter
picture of the fan relay for 1993 mercury topaz
the alternator will be on the end of the engine that has the drive belts or serpentine belts, alternators are belt driven.
The 1993 Mercury Tracer Wagon takes 20" drivers side, 18" passenger side and 14" rear wiper blades. Be sure to lookup exact part numbers by vehicle make, model and year to ensure correct lengths and attachment.
No check , Just drain and add 2.83 qt. ATF in the speedo hole !
You do not need a picture. Look at the engine. On the very bottom of that engine is the oil pan.
BIG JOB! Get a manual on your car from the parts store and a double helping of patience and get started.
Turn signal flasher?
The radiator Petcock is located on the Driverside of the radiator at the bottom, if you remove the splash guard you should be able to see it.
A red button probably in the trunk or fender-well cover of a wagon. Look under a cover.
There are five steps on how to replace the vanity visor mirrors in a 1993 Mercury Tracer wagon. Some of the step-by-step instructions are unscrew the visor fasteners and lower the visor, and then make sure to use the pocket screwdriver to unclip the wiring harness from the visor.
R-12 was outlawed in 1992. Why don't you use R-134A. Put in into the low-pressure port.