passenger side in the transmission bell housing.
the crank sensor is on the passenger side of the car on the back of the engine. Check right up there by the transmission housing.
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
The 1994 Ford F1 50 crankshaft sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
where is the crankshaft sensor on a 1994 dodge pickup with a 5.9l engine?
It is located on top of the transmission next to where is mounts up with the motor
I am not sure of what year you are talking about. But the 1993 and 1994 Altima does not have a crankshaft sensor(crankshaft position sensor) .....
There is a crankshaft position sensor , at the front of the engine
where is the crank sensor for 1994 toyota corolla 1.6 ltr
Crankshaft sensors were not used in 1994 models.
The crank position sensor on a 1993-1997 intrepid with the 3.5 liter is located on the passenger side of the transmission bell housing ( top ) breeze to change and usally fixes the cold starting issue with these automobiles ( usally ) for $40 or less it is worth a try!!!!!
It does not have one
its located in the distributor.
The 1994 Volvo 850 crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Crankshaft sensor on a 1994 Trooper is located behind the passenger side motor mount near the bottom of the engine. If you look behind the front passenger wheel and behind the suspension support, your can see the sensor and wire. It is a tight fit to remove it.
That year did not have one. It has a module in the distributor.
1994 corvette quit accepting more and more throttle then died and wont crank
I don't know what that problem is but if you find out what the problem is could you email me at firstname.lastname@example.org and let me know!! I have the same problem with my 1994 3.3l intrepid! I have a 1993 3.3l intrepid that's doing the exact same thing. I've had the crank sensor changed out, the cam sensor changed, checked all fuses and it's still doing it
I cant remember if a 1994 had a distributer or not. If it has a distributer, there is no crankshaft position sensor. That information is a calculated value using the input from the distributer stator(pickup coil). If there is no distributer, then there will be a crank sensor on the front of the engine down by the crank pulley.
The crankshaft position sensor is mounted on the front of the engine, just to the left of the crankshaft pulley ( when you are looking from the front of the Explorer. Helpfull
you cant you cant
It goes into the top of bell housing.
It is behind the Timing Cover. Torwards the crank pulley.
behind the harmonic balancer
It is bolted to the bell housing on the passenger side.