Dodge Intrepid
Ford Explorer Eddie Bauer
Ford Explorer Limited

How do you change a driver side low beam headlight on a 2000 Dodge Intrepid?

161718

Top Answer
User Avatar
Wiki User
Answered
2008-01-04 02:49:42
2008-01-04 02:49:42

Unlike other cars, the Intrepid requires you to remove the entire headlight housing. This is very simple, there are to long bolts on top of the housing that hold the housing on. Simply remove these bolts, untwist the bulb, replace the bulb.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


battery on a 1999 dodge intrepidYou may have to remove the front driver side wheel to gain access to the battery compartment. At least that's where it is on the 1998 Dodge Startus. hope this helps.

Right behind the headlight on the passenger side.

A 2001 Intrepid does not have an oil change light.

how to change oil pressure switch in 2001 Dodge Intrepid I need to look at a diagram

It is on the front of the driver side of the block.

Driver side rear of engine block.

Driver side of the engine, under the exhaust manifold.

Open the hood to the engine compartment. Take hold of the headlight connector. Push the connector in and turn at the same time. The lightbulb will come out. Reverse the process to install the new lightbulb.

A 1994 Intrepid is OBD1. The connector is a 6 way under the dash on the driver side.

The fuel filter 1995 dodge Intrepid is on the passenger side. The filter is towards the back of the car.

Dodge Intrepid was created in 1993.

With the hood up look at the outer end of the Headlight, You will see what looks like a snap together piece. wiggle the corner light and this will help you to see the clip that has to be moved in order for the light to slide out so you can change the bulb...I myself just put new headlights in my 96 dodge intrepid.

Driver side of the block.Driver side of the block.

No, they will not work, the Intrepid uses a 9007 (hi & low beam in one bulb), the Avenger uses a 9005 & 9006 (separate bulbs for hi & low beam), therefore neither the headlight housing nor the headlight bulbs will interchange.

1999 dodge intrepid is not starting I change crank and camshaft sensor and it stall will not start what can i do next.

In the housing behind the right front headlight, under the hood.

1999 dodge intrepid rear windo don't know working i change 2 time same place you can Email .e sunilpatel2002@hotmail.com

Driver side of the engine, just below the exhaust manifold.

How do I change the oil pan gasket on a 1999 Dodge Intrepid with 3.5 engine, what is the proper torque for the bolts.

See my answer on 'How do you change the headlamp on a 2006 Dodge Stratus? Hope it helps ...


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.