Everyone should have a manual, and the library should have a professional shop manual available for copies in the reference section (FOR FREE)...read up and fix 'em like the pro's...! :) Dave
See posting for "How do you change the headlamp bulb in a 2003 Grand Prix?" All these model years are similar in production for the headlamp assembly.
A massive hammer and lots of money
The orifice tube is located in the line at the condenser discharge connection.
how do you change a headlamp on a Toyota rav 4
what tools do i use to change the front brakes in my 2003 Pontiac grand prix
where is the fuel filter located on a 2003 Pontiac sunfire
How do you change the windshield washer pump on a 2003 Pontiac Grand Am
2 sliding bars hold headlight in remove and pull headlamp forward and out
You have to remove the front bumper to change the head lamp , i did it one time on my Mazda 6 2003 . Regards Abdullah al brahim from K.S.A
with ignition switch problems i find its easyer to replace the hole colum with another one from a junk yard, there is a lot of special tools to take a colum apart or just fork out the cash to have a lock smith to change it
Open the hood to the engine compartment of your 2003 Mitsubishi. Take hold of the headlamp connector. Push the connector in and turn at the same time. The headlamp will come out. Reverse the process to install the new headlamp.
With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. Hope this helps. G These instructions are similar from around '96 to '03 grand prix model years all trim levels.
Take it out and put a new one in!
The front bumper facia needs to be removed to access headlamp assemblies.
they are H4
Jack up vehicle and change the rear plugs from underneath!
Standing in front of the bad headlamp, with the hood open, notice the two black tabs sticking up behind the headlamp assembly. These are locks that hold the headlamp assembly in place. Remove the locks by wiggling and pulling straight up. Now the headlamp assembly will drop out the front far enough to twist out the bulb socket to change the bulb. Reverse for installation.
Owners manual lists the mileage to change it. Don't have one then change it at 50,000 miles.
How to change oil pressure sensor on 3.4 sfi
there is two rods that go through the housing from the top. turn them to unlock and pull up and out then the whole assembly comes out and you can change the bulbs.
Where are the freeze plugs on a 2003 pontiac grand am
18 gallons found at http://www.new-cars.com/2003/pontiac/pontiac-aztek-specs.html