Top Answer
User Avatar
Wiki User
Answered 2008-10-21 04:09:56

1 disconnect battery. (the wires to the starter pack a whallop if they short out or ground unexpectedly) 2 disconnect wires to solenoid. (the solenoid is on the starter. the main wire from the battery goes straight down to the starter. follow this under and behind the engine to find the starter location) 3 unbolt starter from transmission. (there are two if i recall, maybe three) 4 installation is the reverse, but you'll have to reset the the stereo and clock when you are done.

User Avatar

Your Answer

Related Questions

The starter on a Mazda mph is on the left side of the engine. It is at the rear, against the bell housing.

how to change oil and filter on a mpv 2000 mazda

the solenoid is on the starter. It's the part the wires go into.

As per NO!

2001 Mazda MPV does not have a timing belt, it has two timing chains.

instructions on how to install engine valve cover gaskets on l996 Mazda mpv van with 3.0 engine.

Mazda MPV was created in 1989.

Can a Mazda 626 engine fit in a Mazda MPV mini van?

Where is the thermostat located in a 2001 Mazda mpv

how many motor mount has a mazda mpv 2000

The heater core in a 1994 Mazda MPV is under the dash on the passenger side. The dash has to be taken apart to change out the heater core.

The Mazda Mpv 2000 timing chain

What is the cost to replace the head gasket on a Mazda MPV?

how remove headligth lenses for 2004 Mazda mpv

where is the position of the start relay in a the 2000 mazda mpv

Brake fluid location in 1992 Mazda mpv

Go to they have step by steps

The starter on the 3.0 (4WD) is located low on the passenger side of the block. It is difficult to get at because the differential is also on that side. -RJC

size spare tire mazda 2003 mpv van.

how many oxygen sensors are on a 1997 Mazda mpv lx

timing marks 2.5 mazda mpv free diagram

how to reset a fuel pump on a Mazda MPV van 2000

what is the firing order for a 2000 Mazda mpv 2.5L