To change the starter on a Chevy Celebrity with 2.5L engine:
1. Disconnect the battery ground wire. Use gloves to avoid getting acid on your skin.
2. Raise the front of the car to a suitable height for you to work under it. Use suitable blocks for the rear wheels, and put jack stands under the front.
3. Disconnect the wires from the starter solenoid. Take note of where each wire was so you can put them back correctly.
4. If there is a rear brace on the starter remove it.
5. Remove the two bolts that hold the starter to the block. If there are any shims between the starter and the block save them to put on the replacement starter.
6. At this point the starter should easily pull out of the block. It is a little on the heavy side so don't let it fall on you.
Re-installation is the reverse. Be sure to put any shims back in place.
If it is a 2.8 it has 2
Does your 1986 Chevy Celebrity have the 2.5L 4 cylinder engine or the 2.8L V6?
the only way i could figure out how to get the starter out was to remove the right engine mount
To change the starter motor on a Chevy Celebrity: 1 Disconnect the battery ground. Use protective gloves. 2. Set the parking brake. Raise the car as required and put on jack stands. 3. Disconnect the wires at the starter solenoid. Take note of where they come off so you can put them back on. 4. If there is a brace from the starter to the block remove it. 5. Take out the two bolts that hold the starter in place, pull the starter out of the bell housing. If there are shims between the starter and the bottom of the engine block save them for use with the replacement starter. Reverse the process to install a replacement starter.
I found one source that says a 1986 Chevy Celebrity has a curb weight of 2714 pounds. Different options would change that weight.
The spark plug gap for a 1986 Chevy Celebrity with the 2.5L 4 cyl engine is .060".
To change the front blinker bulb on your 1986 Chevy Celebrity simply reach up behind the bumper and unplug the socket from the fixture. Replace the bulb in the socket and plug the socket back into the fixture.
The starter is mounted to the bottom of the block at the bell housing end, side of the engine near the radiator.
To change the headlight bulb on your 1986 Celebrity: 1. Take out the screws and remove the headlight door. 2. Remove the screws and take out the retainer that holds the bulb in place. 3. Pull the headlamp bulb out enough to unplug the wires. Install the new bulb in the reverse order.
Replace the seat belt.
Please clarify your question as in front or rear axle.
On the V6 the ignition module is under the distributor cap.