How do you change a water pump on an 1988 corvette?

Where is the fuel pump fuse on a 1989 corvette

how to change a fuel pump in a 1998 Chevy Corvette

Yes. Try to find another car in the junk yard that has the type of water pump you want to use and take all the pulleys and brackets from it.

It covers the impeller. The opening the cover covers allows the impeller assembly to be removed or installed into the pump housing.

Odds are you have an optispark unitl. If so it is under the water pump on the front of the engine. Look up optispark replacement on LT1 or C4 Corvette.

i need to know what bolts to losen so i can change water pump belt on 1988 Nissan patherfinder

ask these guys www.callawayownersgroup.com

Need more info, engine type.

2 hours max....

Pretty sure it's part of the fuel pump assembly mounted inside the fuel tank.

i'm pretty sure they can. just have to find the right store.

Passenger side , behind front wheel well. Make sure that you remove the fuel pump fuse and run the car till the motor stops so that you remove the fuel pressue when you go to change the filter

Drain the water from your 1988 Dodge Ram cooling system. Remove the water pump belt. Remove the water return hose. Remove the water pump retaining bolts. Reverse the process to install your new water pump.

All fuel pumps are fused, check the fuse block on the passenger side of the dash

The Fuel pump is located inside the gas tank with the fuel level sending unit.

the water pump is part of the timing belt or chain. you have to take the belt or chain off to change the water pump. if you change the water pump, change the belt too.

how to change water pump of vito

How do you replace the water pump on a 1988 Cadillac Seville?

Unless there is an access panel above the fuel pump, yes you must drop the tank.

The 1988 VW Beetle, not sold in the U.S., has an Air Cooled engine. It has no water pump.

Begin by removing the fuel pump wiring harness. Remove the fuel pump lines. Remove the fuel pump retaining bolts. Reverse the process to install your new fuel pump.

Check water pump and pump gasket.

How to change a water pump on a 94 hyundai scoupe?

how do you change a water pump on 1993 Mercury Cougar

How do you change a water pump on a 2005 f 250

I dont know how to change the water pump??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????

how to change a water pump Kia Sedona 2002

How do you change the water pump in a 2002 ford Taurus

how to change water pump on 2007 ford fusion

How to change a water pump on a 1997 Pontiac Transport

how to change a water pump on a 2002 mercury mountineer

the fuel pump is located under the fuel lid remove the lid and you will see a square plate with bolts remove bolts and pump sender comes out change pump then reassemble

The water pump is located behind the Timing belt, the belt covers and belt needs to be removed to gain access to the water pump bolt,once you have removed the old one make sure you clean the surfaces where the new gasket is going, as it is a time consuming job to do it again

How do you change the water pump on a 1997 chevy malibu?

no you do not have to change the timing chain when changing the water pump.

how to change water pump on1999 mercury sable

How do you change a water pump impeller on a 1993 Johnson out board

how do you change a water pump on a 1985 Yamaha yz 250

How do i change out a water pump on a 1999 playmonth breeze/engine 2.4

Remove serpentine belt, alternator, and power steering pump. Remove 4 water pump pulley bolts. Remove water pump housing bolts. Remove water pump.

You only change the fuel pump when it fails. But do change the fuel filter every 50,000 miles.

You can change the water pump on your 2000 Mercedes E3 20 by first removing the water pump belt. Next remove the water lines. Remove the bolts that hold the water pump in place. The water pump will pull outward and can be removed. Reverse the process to install the new water pump.

Ooh, this is a fun one. The water pump is driven by the timing belt, so you have to remove and replace that to change out the water pump. ~Pengauin

= Where is the fuel pump reset switch on a 1989 corvette automatic? =

i need help with the temp.gage in a 1988 ford ranger

when changing the water pump it is also adviseable to change the timing belt as well.

you have to take the timing belt cover off and timing belt to get to the water pump

if its an LT1 motor yeah it happens

It looks to me that you may need to remove the water pump and the air intake system to reach the distributor cap. I'll find out this weekend for sure!!!

Examine the water pump. Look for water around the base of the pump after the engine is turned off.