Lift the plastic cover off the top of the engine the Air filter lid is towards the back of the engine.loosen star bolts with an Allen key and lift lid towards you. The filter is inside. Replace and refit lid and plastic cover
If by S16 you mean a Phase1 S16 then you need to take off the coil pack coverplate, the one that the fuel lines' securing metal plate is bolted onto. So 8 bolts need to be undone. Then you see the coil packs, 4 of them. Unclip them one by one and gently wiggle them out. The spark plugs are now accessible. I would recommend doing the swap one at a time so the coil packs can be placed back to their original cylinder.
You will need the right specified oil grade for your engine and the right oil filter (check with the dealership)
Warm engine (not too hot!) then switch off engine Open oil filler cap
Lift car to reach drain plug and get a container with at least a 5l capacity (the bigger the better as long as it can fit under the car where u can pour the old oil
Have container ready to catch oil, open drain plug under car with wrench, use hand to unscrew when the plug is loose so u don't drop the drain plug in the container
Wait for oil to drain
Remove and replace oil filter
Wait for oil to drain again
Pour a cup of new oil let it come out of drain plug and now close the drain plug
Remove lift
Pour the right amount of oil in the engine use the dip stick to help you.
Close the oil filler cap start engine do not rev it and let it warm up or drive very slowly.
Always check the dipstick if you need top ups regularly
Hope you service other parts as well fuel filter, spark plugs, air filter etc.
With a commonly used oil filter spanner or strap or last resort screwdriver through it!
SPARK PLUGS ARE NOW PRE SET AT MANUFACTURE. THE GAP SHOULD BE 0.7MM. BUY NEW ONES AND THEY ARE SET CORRECTLY.
check plugs or coil packs..
yes
0.9mm.
fanbelt on a 306 hdi how do fit it
how to remove indicator stalk and cowl from Peugeot 306 lx
really easy fix! what model 306 is it? regards, Simon
To change the wiper blade on a Peugeot 306 unclip the old part from the mount. Take the new wiper blade and slide it into place until it clicks.
A Big Hammmer or angle grinder
no se como cambiarlo
The Peugeot 306 is manufactured by the French manufacturing company Peugeot. It was in production from 1993 to 2002 and was a replacement for the Peugeot 305.
I had this problem and it was broken solder on the timing circuit board for the glow plugs