0
Best Answer
It requires a special socket with a slot in the side so as not to harm the wiring.
Wiki User
∙ 15y agoThis answer is:
Add your answer:
Earn +20 ptsQ: How do you change an O 2 sensor for a 1995 Chevy Beretta?
Write your answer...
Submit
Still have questions?
Related questions
Spark plug gap Chevy beretta 1995?
0.060
I have a 1995 Chevy Beretta with a bad 3.1L and a 1993 Chevy Lumina with a good 3.1L motor is this a possible swap?
the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta
I have a 1995 Chevy Beretta . What would make the low coolant light stay on when there is enough coolant in the car?
There is a sensor valve located inside the reservoir its may be bad
Where is the transmission solenoid on a 1995 Chevy beretta?
inside the transmission bell housing
Where is the fuel filter located on a 1995 Chevy Beretta?
Behind the fuel tank.
Where is the fan sensor located for a 1995 Beretta?
It is on the intake manifold near the thermostat housing.
Where is the temperature sending unit for a 95 Chevy beretta?
The temperature sending unit for a 1995 Chevy Beretta is on the front of the engine. It is between the front of the engine and the radiator inlet/outlet.
Why does your 1995 Chevy beretta taillights keep blowing the fuse Help?
then there is a short some where!
Where is the fuel pressure relief valve on a 1995 Chevy Z26 Beretta?
In the gas. Of course.
Where is a thermostat in a Chevy beretta v6 1995?
Follow the upper radiator hose to the engine. It is behind there.
Will a 1995 Chevy Beretta 3.1 engine work in a 2001 Chevy Malibu 3.1?
As long as the are both front wheel drive.
Where is the IAT sensor located on 1995 Chevy G20?
A 95 did not have IAT sensor
Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.