answersLogoWhite

0


Best Answer

It will require a special socket with a slot down the side so as not to damage the wiring. It may be cheaper to have a shop do it as the sensors do not go bad very often.

User Avatar

Wiki User

โˆ™ 2008-11-19 12:39:12
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change an Oxygen sensor on a 1995 Chevrolet Beretta?
Write your answer...
Submit
Related questions

Where is the oxygen sensor on a 1994 Chevrolet Beretta?

The oxygen sensor is in the rear exhaust manifold. You should be able to see it by looking behind the engine from inside the engine bay.


Does the speedometer cable hook to the transmission on a Chevrolet Beretta?

It has a speed sensor on the transmission.


What is a 2002 Chevrolet Impala gas tank oxygen sensor?

There is NO Oxygen Sensor in the Gas Tank.....


Where are the three oxygen sensors located on a 1996 Chevrolet Lumina 31?

where is the oxygen sensor located on a 1997 Chevrolet lumina


Chevrolet Tahoe has two oxygen sensor how can you check tham?

2002 Chevrolet Tahoe has two oxygen sensors How do I check them ?


1996 beretta oxygen sensor?

There is normally one before the catalytic converter and one after.


How do you replace the oxygen sensor on a 1994 Chevrolet Astro van?

You bring it to a service station and tell them to replace the oxygen sensor.


Where is the oxygen sensor on a 1988 Chevrolet celebrity?

If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.


What causes the low coolant light to stay on a 1996 Chevrolet beretta?

There is a sensor in the side of the radiator that is most likely defective.


How do you change oxygen sensor on a 2006 Chevy aveo?

How do you change oxygen sensor on a 2006 Chevy aveo?"


How do you change oxygen sensor in 1992 Toyota Corolla?

How do you change oxygen sensor in 1992 Toyota corolla? Is there a model engine 4A-FE without a oxygen sensor?


Where is the oxygen sensor located on a 1998 Chevrolet Malibu?

All oxygen sensors are located in the exhaust system.


How do you change an oxygen sensor in a 2002 Pontiac Grand Am?

Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville


How do you change the oxygen sensor in a 1992 Chevrolet Camaro?

It will require a special slotted socket that can only be used for the one purpose. The cost does not justify the means.


Change oxygen sensor on 95 Oldsmobile cutlass ciera?

Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.


Why does the low coolant light stays on my 1996 Chevrolet Beretta?

There is a sensor either in the coolant recovery jug or the radiator side tank that is defective.


Where is the oxygen sensor located on a '89 Beretta w 28L V6?

it should be located on the rear manifold


Where is the oxygen sensor in a 1986 Chevrolet Nova?

It is in the exhaust system before the catalytic converter.


Where is the oxygen sensor on a 1998 Chevrolet Malibu?

It is in the exhaust either before or after the catalytic converter.


Where is the oxygen sensor 2000 Chevrolet S10 2wd 4 cylinder?

extended pickup


How do you change Chevrolet Malibu Pressure oil sensor?

I'm not a mechanic


What kind of socket is needed to change the oxygen sensor on 97 dodge caravan?

It is called an oxygen sensor socket.


Where is the oxygen sensor located on a 2003 Chevrolet Impala?

There is one before and one after the catalytic converter.jd


Where is the oxygen sensor on a 2002 Chevrolet Malibu?

All oxygen sensors are located in the exhaust system either before or after the catalytic converter.


How do you replace a front oxygen sensor bank 1 sensor 1 code 135 in a 2004 Chevrolet Impala LS?

It requires a special socket and it is only good for oxygen sensor replacement. Buy the socket and unplug the sensor ,install the socket and remove the sensor.