Dodge Dakota
VW Passat
Ford Expedition XLT
Ford Ranger XLT

How do you change an oil pump on a 1992 dodge Dakota v8?

181920

Top Answer
User Avatar
Wiki User
2008-04-16 16:20:25
2008-04-16 16:20:25

Removal: Remove the oil pan. Remove the pump-to-rear main bearing cap bolts. Lower the pump from the truck. Installation: Pour clean oil into the pickup tube to prime the pump. Put the new pump in place (make sure hex-shaped driveshaft aligns with pump). Install & tighten bolts to 30lbs. Install oil pan & tighten bolts to 200 in. lbs.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

i have a 1999 Dakota 3.9 and fuel regulator is on top of the fuel pump on the fuel tank... i have a 1999 Dakota 3.9 and fuel regulator is on top of the fuel pump on the fuel tank...

User Avatar

i have a 1992 dodge Dakota 4x4 and a 1989 Dakota 4x4 and the fuel pump is inside the fuel tank. both trucks have the 3.9 v6 engines.

User Avatar

the fuel pump is located inside the gas tank.To change fuel pump, take off the bed of your truck and unscrew the white thing on top of the gas tank. That is your fuel pump.

User Avatar

Trust me, it works. Your problem is the fuel level sensing unit connected to your fuel pump. Change your fuel pump and your problems will be solved.

User Avatar

It is on the bottom of the engine, oil pan has to be removed.

User Avatar

Remove the fuel tank or remove the bed.

User Avatar

For all 1992 Dodge Dakota V6 andV8 engines:All of the water pump bolts are to be torqued to 30 ft. lbs.For 1992 Dodge Dakota 4 cylinder engines:Upper bolts are torqued to 21 ft. lbs.Lower bolts are torqued to 40 ft. lbs.Waterpump housing-to-cover bolts are torqued to 105 inchlbs.

User Avatar

the fuel pump may be in the gas tank,if so youll have to drop the tank.

User Avatar

underhood fuse box, lid has diagram on underside that show which one it is.

User Avatar

It unscrews. There is a special wrench you can buy for this, or make your own.

User Avatar

go rent the tool for your parts supply place

User Avatar

The fuel filter on the 1999 Dodge Dakota is a combination Fuel Filter/Pressure Regulator. It is mounted to the top of the Fuel Pump which is mounted on the fuel tank. You must remove the fuel tank to change the fuel pump. Depressurize the fuel system, Drop the tank, replace the pump.

User Avatar

The fuel filter is in the gas tank, along with the pump. You will not be able to change this filter, unless you change the pump too.

User Avatar

Drop the gastank and access the fuel assembly wher in your fuel pump will be.

User Avatar

In the fuel tank with fuel pump. You should not have to change the filter.

User Avatar

A Dodge Dakota does not have a reset button. The fuel system is computer controlled with relays.

User Avatar

The easiest method is to remove it, and plug the ports on exhaust manifolds and catalytic converter.

User Avatar

The easiest way to remove a bypass hose on a Dodge is to cut it off with a sharp knife. The hose is cheap, I replace it with every water pump.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.