Ford F-150

How do you change ball joints on a 1995 ford f150 truck?

151617

Top Answer
User Avatar
Wiki User
2009-02-04 18:08:31
2009-02-04 18:08:31

kick it between the legs and hope it dont bite back.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how to replace lower ball joints on 1995 4 wheel drive Nissan truck

User Avatar

How do you change the lower ball joints on an 2004 envoy

User Avatar

On you tube.( Eric the car guy )show how to do this.

User Avatar

No, the ball joints are much larger on the C10.

User Avatar

Replacing Ball joints Check Related Links Below

User Avatar

lmc truck (www.lmctruck.com). there is a diagram for upper and lower ball joints for the front end.

User Avatar

You change the control arms, upper and lower. The ball joints are manufactured into the control arms.

User Avatar

The lower ball joints have to be pressed out. The upper ball joints are part of the control arm, so the complete upper assembly has to be replaced.

User Avatar

need video on how to put upper ball joints in a 97 merc mountinare

User Avatar

How to change upper and lower ball joints on a 1997 ford explorer all wheel drive?

User Avatar

Check your ball joints and your spring hangers

User Avatar

You need to remove the spindle and press out the ball joints & press in new ones

User Avatar

This is fairly labor intense and can be somewhat dangerous. Pick up a Chilton's for the info and safety measures to take.

User Avatar

When replacing parts of a car, it is important to know the general cost of the fixes. To replace the ball joints for a 2003 F150 pickup truck, it is going to cost a person $40-$60 to do it on their own.

User Avatar

You can not just change the ball joint , you have to replace the whole lower control arm with ball joint.

User Avatar

The CV joints on a 1995 Ford Taurus can be replaced by removing the front tires, and the nuts on the lower ball joint. Next, the lower ball joint will need to be removed and the CV joint can be removed.

User Avatar

No you do not need a press. I recently did upper and lower ball joints on my 95 T Bird and it is all bolt on parts. you cant buy just the ball joint, you have to get the whole control arm with the sealed ball joints already in it.

User Avatar

Check ball joints, tie rods, drag links, u-joints, sway bar links, for grease zerks.

User Avatar

it depends if you have a ball joint presser. i would say about an hour

User Avatar

Get a manual first. It is a lot of work, requiring a big drill to remove the rivets that hold the ball joints in from the factory. Unless you are a capable mechanic with proper tools and safety knowledge of working with auto front ends, don't attempt it yourself.

User Avatar

You can't service the lower ball joints by themselves. You must replace the entire lower control arm.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.