It is easy but everything has to go inorder. Get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM and it will help on the next repair and get you acquainted with your car also.
easy is relative. i don't alot of work on my cars but it's fairly straight forward. front discs are easier to change. i'd recommend changing with a friend. 1. loosen lug nuts 2. jack car up 3. take off wheel 4. make sure emergency brake is off, and remove it from brake assembly. it's a bolt on top w/a clamp and spring, and a bolt on the bottom of the arm. 5. remove 2 bolts holding caliper in place. pry caliper off rotor (i find using a big flathead screwdriver does best...wedge it between rotor and caliper) 6. remove 2 bolts holding caliper together and pull pads out of calipers...careful not to damage pins/shims 8. push piston back into boot so new pads will fit. this will require a tool. front brake piston can be pushed with a c-clamp, but rear requires a tool fitting the '+' shape. available in autoparts store...get a socket extension for your rachet too. (don't try to do with anything else, or you'll just get frustrated) turn clockwise and simultaneously push. 9. put new pads in, aligned same way as old ones 10. slide back on rotor and assemble everything in reverse order of disassembly
should take a couple hours.
Purchase 2 quarts of the correct brake fluid for your car. Starting with the R rear then the L rear then the R front then the L front, bleed each wheel thoroughly. Allow the fluid level in the reservoir to drop low but NOT empty then refill and continue. When fluid coming out is as clean and clear as new top off the reservoir and you're done.
If your talking about the brake bleeder, it is on the caliper/brake cylinder at the wheel.
The bleed screw on the calipers of brake systems are for 'bleeding' air out of the brake lines.
You can access the middle brake light from the inside of your 2000 Dodge Neon cargo compartment. Remove the brake light wiring harness. Remove the brake light retaining bolts. Reverse the process to install the new brake light.
change the light bulb,
Some cars have 2 switches on the pedal. one for brake lights and one for the cruise cont. Did you replace the right one??
how to change rear brake pads to Nissan maxima 96
change rear brakes on a 2004 Nissan maxima
how to change the rear tail light bulb on a 2004 Nissan maxima
how do I ajust the emergency brake on a 2005 Nissan maxima
Brake fluid for 95 maxima
Maxima comes with Auto adjustments. All you need to adjust is brake pedal free movement.
take it to a brake specialist
Driver side firewall in the hood where u add the brake fluid
How do you change brake pads on a 2002 Nissan Sentra? How do you change brake pads on a 2002 Nissan Sentra? How do you change brake pads on a 2002 Nissan Sentra?
no
Go to autozone
Check the brake light switch down on the brake pedal.