1. Open hatch and remove the 2 hex screws on the side of the light.
2. This will loosen the light. It is still held in by the main wire and a push-in plastic tab. Pull the entire light assemble straight back. You have to pull fairly hard to pop the light out of the plastic tab. Don't pull too far out back (because of the main wire).
3. There are 3 bulbs in each side. Brake light is the top bulb. Turn counter-clockwise to unscrew. You can now replace the bulb.
4. You might as well replace all 3 bulbs. Good auto parts stores sell single bulbs for approx. $1.50 each. Reverse steps to reassemble.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
The brake light fuse on a 2003 Jeep Grand Cherokee can be found by looking at the cover to the main fuse box. It identifies each fuse and its location.
A short in the brake light circuit.
If equipped, it is above the liftgate glass.
Failed circuit board on the back of the light.
You already have a 3rd brake light behind the rear glass. Do you mean change the bulbs? If you do need to change the bulb then all you need to do is take off the paneling inside on the liftgate and you will have access to your lights.
They aren't. The brake light circuit is not connected with the headlight circuit.
You need to check the wiring for power to the bulbs.
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.
passenger side fuse panel....#2
its not a switch its a fuse check the fuse and the light fuse is under the driver side dash look in your manual for brake light fuse
Either the brake light switch is out of adjustment, or has gone bad.
take it to a garage SMARTY
The circuit board/socket in the tail light has failed.
Mine simply needed brake fluid to fill it to the line indicated on the brake fliud container.
Time for an oil change.
The brake light switch is behind the brake pedal.
Defective or mal-adjusted stop light switch? Usually located at the upper end of the brake pedal under dash area
Check the bulbs in case they have fused, next check the fuse, and finally it could be the brake light switch which may need replacing
Check socket for power/ground corrosion Check stop light switch for power on one side Check fuse
Those lights are on because the computer has detected a fault and set a code. You will need to have the system checked with a scan tool.
Check ALL of the fuses with a test light then you will know they are good
what do you have to do to change the center brake light